Search: Posts Made By: Telme
Showing results 1 to 6 of 6
Search took 0.01 seconds.
08-26-15, 08:13 AM
Replies: 26
Views: 15,237
Posted By Telme

insulation to existing floor

First let me say Furd is on the right track. Renovations to any existing house or building are always difficult and typically 50% harder to do than when the house is being built. You are looking for...
08-26-15, 07:11 AM
Replies: 6
Views: 2,868
Posted By Telme

Broken plastic draw

Well first let me say there are several types of plastics and some have a petrochemical structure that will not allow them to be glued. Most plastics can be welded but this may not be feasible in...
08-26-15, 06:55 AM
Replies: 3
Views: 992
Posted By Telme

Bathroom Mould Removal

Bathroom mould are fungi spores. It possible they may be living behind the caulking but this means the caulking is not adhered to both surfaces.
To kill mould I know of two methods and I need to...
07-21-15, 05:36 AM
Replies: 10
Views: 62,267
Posted By Telme

it would be good to know what the table is made...

it would be good to know what the table is made of, wood, wood veneer, fibre glass, resin or a plastic composite. High gloss can be a brushed product which usually means an oil based flues gloss...
Replies: 7
Views: 930
Posted By Telme

ok reading this you infer that the leakage and or...

ok reading this you infer that the leakage and or damage resulted from the removal of the part. Assuming this is fact then the next question is what was the original fault / defect and did this...
Replies: 1
Views: 412
Posted By Telme

Post House Alarm Networks NX4

Hello, I have a networks NX4 system with 3 movement sensors and one smoke alarm sensor. The movement sensors are shown as 1,2 ,3, on the key pad with the smoke alarm as 4. Renovating the rumpus...
Showing results 1 to 6 of 6


 
Forum Jump