Search: Posts Made By: goldstar
Showing results 1 to 25 of 200
Search took 0.02 seconds.
Replies: 5
Views: 2,095
Posted By goldstar

Check with an experienced nursery. They can...

Check with an experienced nursery. They can recommend suitable trees for your size and space requirements. Note that most evergreens can have their size maintained through annual trimming..
Replies: 8
Views: 881
Posted By goldstar

My first thought would be that you left the oven...

My first thought would be that you left the oven light on. My GE has a separate switch on the control panel for the oven light. Easy to forget. You open the door, light is on and oven is warmed from...
11-20-18, 11:27 AM
Replies: 3
Views: 2,396
Posted By goldstar

First, is the door connected to the trolley at...

First, is the door connected to the trolley at this time? second, are the photo sensors aligned and operational. Your forward - back - light blinking sounds like a misalignment or a defective sensor.
Replies: 3
Views: 1,226
Posted By goldstar

That sounds like a plan. Just as an aside, I...

That sounds like a plan. Just as an aside, I would check the drain for hair clogs first. They may not be the source, but can block waste water
My money is on the teen. Keep us posted.
Replies: 6
Views: 856
Posted By goldstar

Click on and read the sellers "bio"....

Click on and read the sellers "bio". Interesting.
Replies: 7
Views: 932
Posted By goldstar

First, are you still running old gas ( 2 years...

First, are you still running old gas ( 2 years old) to the carb? Second, when was the last time you cleaned and gapped the spark plug.? Third, how did you reset the needle valve(s) on the carb....
Replies: 5
Views: 1,893
Posted By goldstar

I would be suspecting the fuel system. It's...

I would be suspecting the fuel system. It's possible that a bit of sediment from the tank or carb is partially blocking a carb jet. I would tear down an clean the carb and drain all old fuel from the...
Replies: 19
Views: 2,742
Posted By goldstar

Glad you found the problem. Thanks for the input....

Glad you found the problem. Thanks for the input. It may elp others in the future.
Replies: 8
Views: 2,263
Posted By goldstar

Dumb question but since you replaced the valve,...

Dumb question but since you replaced the valve, did you reopen the shut off on the supply line?"
12-13-17, 08:19 PM
Replies: 5
Views: 4,286
Posted By goldstar

Welcome to the forums. Please explain which...

Welcome to the forums. Please explain which blower you are blowing into and how you are doing it.
11-16-17, 07:20 PM
Replies: 7
Views: 3,239
Posted By goldstar

If you have not cleaned the flame sensor in the...

If you have not cleaned the flame sensor in the past year or two, it could be the problem. On your furnace it is between the number one and number two burner - counting from the left. Its held by one...
10-17-17, 02:42 PM
Replies: 7
Views: 2,000
Posted By goldstar

It sounds like something is momentarily...

It sounds like something is momentarily contacting the inducer motor blades for a few seconds as the motor starts. the motor shaft may be worn, allowing the fan to contact the housing. Once up to...
Replies: 2
Views: 1,709
Posted By goldstar

Your battery may show a nominal 12 volts with no...

Your battery may show a nominal 12 volts with no load. Test it with the key and kill switch on and - making sure it is in neutral - hit the starter switch. Your meter on the battery will probably...
09-09-17, 06:37 PM
Replies: 7
Views: 6,524
Posted By goldstar

There are number of meters available. Kill A Watt...

There are number of meters available. Kill A Watt comes to mind It will measure voltage and frequency at the 120 volt level. Once you get that set, the 240 volt should be good.
Replies: 10
Views: 1,213
Posted By goldstar

Been running a pair of Genie / Overhead Door...

Been running a pair of Genie / Overhead Door screw drives for 20 years. One on a single and one on a double door. Worst problem to date was a plastic coupling between the screw and motor. Easy and...
Replies: 10
Views: 3,196
Posted By goldstar

First, welcome to the forums. Could you please...

First, welcome to the forums. Could you please advise the make and model of your bike. It would also be good to know if you or a previous owner added anything to the electrical system.

Have you...
08-05-17, 07:41 PM
Replies: 3
Views: 950
Posted By goldstar

Welcome to the forums. One thing you could...

Welcome to the forums.
One thing you could check is to verify that all other GFI's are set.
I had a similar problem until I found a second GFI chained to the other - one on the front porch and the...
07-27-17, 07:56 PM
Replies: 11
Views: 4,148
Posted By goldstar

If you want to disconnect the outside wires, They...

If you want to disconnect the outside wires, They are all screwed into the splitter ( rectangle box).
There is a nut on each wire which you can loosen with a pair of pliers and finish with your...
07-17-17, 07:21 PM
Replies: 1
Views: 1,364
Posted By goldstar

Just Google 5/8 nylon plugs. Many sources from...

Just Google 5/8 nylon plugs. Many sources from A(mazon) to W)almart).
07-05-17, 08:46 PM
Replies: 12
Views: 1,543
Posted By goldstar

If the leaves on the birch are turning yellow and...

If the leaves on the birch are turning yellow and then dropping, it maybe a river birch. Seems these need treatment by professionals for a manganese deficiency. Also they need regular, heavy watering.
06-30-17, 07:05 PM
Replies: 2
Views: 1,073
Posted By goldstar

It does sound like the cap. First rule is that...

It does sound like the cap. First rule is that you are dealing with 240 volts AC - not 12 DC. Be sure you kill the power before opening the electric compartment on the compressor. You can then...
06-30-17, 06:54 PM
Replies: 4
Views: 1,502
Posted By goldstar

Where are your cold air returns located? For...

Where are your cold air returns located? For example, mine are located high on the wall - opposite the warm air floor ducts in most rooms except the kitchen and baths.
06-30-17, 06:46 PM
Replies: 1
Views: 1,055
Posted By goldstar

One looks like clover and another like wild...

One looks like clover and another like wild strawberry. Not sure about the others.
Replies: 4
Views: 1,675
Posted By goldstar

If you feel that the Yamaha is inferior, why...

If you feel that the Yamaha is inferior, why waste your time considering it.
I've got a 1300 cc twin which only produces about 65 hp. It should be about finding the bike to fit your needs, not...
Replies: 2
Views: 1,029
Posted By goldstar

Not familiar with your model, but did you...

Not familiar with your model, but did you possibly leave the blades engaged when you stopped? That could be a safety shut down, if they are still engaged.
Showing results 1 to 25 of 200
 


 
Forum Jump