Search: Posts Made By: Mcbride
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 20
Views: 3,090
Posted By Mcbride

What big cities are near your area???

What big cities are near your area???
Replies: 7
Views: 9,367
Posted By Mcbride

In your picture the gold unit with the hole in...

In your picture the gold unit with the hole in looks like the unloader valve.
You should be able to get a o-ring kit for it.
Check with your dealer about it settings.
Replies: 5
Views: 1,453
Posted By Mcbride

Make sure all the springs on the...

Make sure all the springs on the carburetor/governor are still there and not broken.
Had the same problem with my chipper vac.
Would not increase rpm's.
I knew it was starving for gas.
Found an...
Replies: 5
Views: 1,453
Posted By Mcbride

Sounds like it's starving for gas. Gas filter???

Sounds like it's starving for gas.
Gas filter???
Replies: 25
Views: 5,216
Posted By Mcbride

Grooves and rust on pad surface of rotor. You...

Grooves and rust on pad surface of rotor.
You might have a stuck pad.
One look at you picture shows a problem.
They need service.
Walk around a parking lot and look at other vehicles rotors.
For...
Replies: 25
Views: 5,216
Posted By Mcbride

From what your picture shows those brakes need...

From what your picture shows those brakes need service so I wouldn't waste my time fighting it.
Sounds like someone wants to make some money.
Shop around for other quotes for that job.
Replies: 25
Views: 5,216
Posted By Mcbride

A little tip when replacing pads. Get the caliper...

A little tip when replacing pads. Get the caliper bracket clean where the hardware goes. Rust builds up in the place the hardware fits into and will pinch the pad slots on the hardware a little...
Replies: 7
Views: 9,367
Posted By Mcbride

If you get it working use a pump conditioner when...

If you get it working use a pump conditioner when you put it away for any long length of time.
Replies: 7
Views: 9,367
Posted By Mcbride

If you can take the pump apart and clean it check...

If you can take the pump apart and clean it check and replace bad o-rings.
Sounds like a bad o-ring on what is called an unloader valve.
Replies: 25
Views: 5,216
Posted By Mcbride

Yes, Junk them. You will be better off with new...

Yes, Junk them. You will be better off with new ones. New pads, new rotors.
Showing results 1 to 10 of 10


 
Forum Jump