Search: Posts Made By: user12386595
Showing results 1 to 9 of 9
Search took 0.01 seconds.
04-27-20, 05:21 PM
Replies: 4
Views: 2,032
Posted By user12386595

I doubt the drain is terminated correctly ...

I doubt the drain is terminated correctly

Condensate-Drain-Air-Gap

<img src="https://inspectapedia.com/aircond/1242s.jpg" width="751" height="751"/>...
Replies: 6
Views: 732
Posted By user12386595

get a turbe of 100% silicon and shoot a big caulk...

get a turbe of 100% silicon and shoot a big caulk wad in that hole. Fill up the whole gap and let it cure fully.
Works great as long as you never need to remove it.
04-27-20, 09:15 AM
Replies: 7
Views: 526
Posted By user12386595

when the GFCI is installed it will have the...

when the GFCI is installed it will have the ground pin on top, hot and neutral on the bottom (upside down) .

This is the reasoning for it:An upside-down position may also help to reduce the risk...
Replies: 1
Views: 961
Posted By user12386595

Take off the vent cover (i don't think thats the...

Take off the vent cover (i don't think thats the correct name for it but "vent" works for me). Cut a piece of material ( cardboard would probably be best) that you can sandwich between the vent and...
Replies: 4
Views: 902
Posted By user12386595

Take a look here....

Take a look here. https://www.antennasdirect.com/combining-uhf-vhf-antenna-signals.html
04-23-20, 03:08 AM
Replies: 4
Views: 807
Posted By user12386595

quote source: bellperformance.com...

quote source: bellperformance.com (https://www.bellperformance.com/blog/bid/114020/guidelines-for-long-term-fuel-storage-of-diesel-and-storage-tanks)
Replies: 11
Views: 971
Posted By user12386595

i use 91% Isopropyl Alcohol. i use it (on a...

i use 91% Isopropyl Alcohol. i use it (on a q-tip) to clean old thermal paste off processors, clean motherboards, clean soldering flux or anything else off a PCB. The only thing that sucks is the...
Replies: 14
Views: 1,817
Posted By user12386595

i haven't worked on that many washer and dryers,...

i haven't worked on that many washer and dryers, but the ones i have worked on, all had a wiring diagram taped to the inside of the rear cover on the control panel.
Replies: 8
Views: 778
Posted By user12386595

the OBD2 system has continuous misfire...

the OBD2 system has continuous misfire monitoring. The only thing with the engine controls that will cause a misfire is the crank sensor (on most cars) since its output is used to determine...
Showing results 1 to 9 of 9


 
Forum Jump