Search: Posts Made By: 31YTech
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Replies: 45
Views: 42,107
Posted By 31YTech

Check around with your local repair shops and see...

Check around with your local repair shops and see if they have a used lower body laying around, I have a few but it's a shame your across the border.....


Good Luck
Replies: 45
Views: 42,107
Posted By 31YTech

Well, It's definitely running way too rich,...

Well,

It's definitely running way too rich, Either the float valve isn't seating or the float has fuel inside. The level is too high or it's sucking too much fuel through the busted main jet boss....
Replies: 45
Views: 42,107
Posted By 31YTech

OK Jason, Test leads on both plug wires...

OK Jason,

Test leads on both plug wires should yeld 2.76 ohms.

Open circuit between each plug wire and the lamination and kill lead terminal.

Kill lead terminal to lamination 9.0 ohms.

...
Replies: 45
Views: 42,107
Posted By 31YTech

Direction of rotation is not your problem, A...

Direction of rotation is not your problem, A Briggs starter will spin in either direction but the starter drive will not engage the flywheel spinning the wrong direction.

I hate to say it, I read...
Replies: 45
Views: 42,107
Posted By 31YTech

Anywhere between the two is fine, This one has me...

Anywhere between the two is fine, This one has me stumped as well. There is nothing to this system but the coil and flywheel magnet with the kill lead disconnected.

I have read about (never seen)...
Replies: 45
Views: 42,107
Posted By 31YTech

OK, Just some basics here; Standing on...

OK,

Just some basics here;

Standing on the right hand side (from seated position) of the tractor installing the coil, Are you installing it with the plug wires coming out of the coil to the...
Replies: 45
Views: 42,107
Posted By 31YTech

:eek: Duuude.....Where on earth did you buy...

:eek: Duuude.....Where on earth did you buy that coil ???


Buy Repair Parts - Briggs & Stratton (http://www.briggsandstratton.com/maint_repair/repair_parts/index.aspx?_dp=1&pno=394891)

You...
Replies: 45
Views: 42,107
Posted By 31YTech

I've never seen a blocked intake or muffler drop...

I've never seen a blocked intake or muffler drop only one cylinder, With everything you have already done and the right side valve specs being a little out I believe I would pull that head. These...
Showing results 1 to 8 of 8


 
Forum Jump