Search: Posts Made By: engin
Showing results 1 to 5 of 5
Search took 0.00 seconds.
Replies: 9
Views: 2,960
Posted By engin

Yes - you are right. The manual for the burner...

Yes - you are right. The manual for the burner calls out one controller and looking at the one on the unit now, it's the L4081B10131 - I wonder if it was changed out?

49181
49182
Replies: 9
Views: 2,960
Posted By engin

Here is the diagram - when setting up the "Heat...

Here is the diagram - when setting up the "Heat Mangler" I had asked Utica for a copy.

49046

Yes - you are definitely right about unhooking the sensor.

As for the water hammer - I was...
Replies: 9
Views: 2,960
Posted By engin

Boiler is a Utica OBT 4. I'm not...

Boiler is a Utica OBT 4.

I'm not considering the "Heat Mangler" in the equation - it's a nice looking paperweight as far as I'm concerned.

The left side of the aquastat is set to 180 and...
Replies: 9
Views: 2,960
Posted By engin

Thank NJT! Here is the aquastat - it's a...

Thank NJT!
Here is the aquastat - it's a Honeywell:
48737

48738

Now, I'm still using the burner for heating. It's set to 180 - does the controller just monitor the overall temperature of the...
Replies: 9
Views: 2,960
Posted By engin

Instant Hot Water Heater to Replace Tired Oil Burner Hot Water Coil

Could I please get a sanity check on my setup before I get going with the torch? The HW coil on my oil burner had been on it's way out for years. I recently picked up one of those instant HW...
Showing results 1 to 5 of 5


 
Forum Jump