Search: Posts Made By: pbro
Showing results 1 to 18 of 18
Search took 0.01 seconds.
04-14-14, 07:22 PM
Replies: 4
Views: 972
Posted By pbro

I ordered and replaced the circuit board and...

I ordered and replaced the circuit board and everything is working fine again.
03-23-14, 01:08 PM
Replies: 4
Views: 972
Posted By pbro

I've determined something is not allowing the...

I've determined something is not allowing the switch on the circuit board to switch the unit on. I can get the fan to work if I force the switch to make contact. Therefore, I'm not sure if something...
03-12-14, 05:57 PM
Replies: 4
Views: 972
Posted By pbro

Honeywell HE360a quit working

Hello all,

I've had a Honeywell he360a connected to my Goodman furnace for (at least) a few years. Other than a solenoid replacement, it's worked fine until recently. The power outlet is wired...
07-13-08, 08:44 PM
Replies: 4
Views: 877
Posted By pbro

Solved!!!

Hey all!

Got it solved! Since the t-stat wire had an additional, unused blue wire...I connected it to the white terminals at the furnace board and t-stat. Everything functioned as it should. ...
07-13-08, 08:09 PM
Replies: 4
Views: 877
Posted By pbro

I had kept the original house thermostat. It's...

I had kept the original house thermostat. It's not programmable and was used on the house for about 1yr when it was built ~4yrs ago.

Low voltage.

I disconnected the thermostat wires at the...
07-13-08, 05:36 PM
Replies: 4
Views: 877
Posted By pbro

Furnace started running in "off" today...please help!

Hey all!
I'm having a problem. Today I switched off the 'cool' mode on our prog. thermostat (Honeywell) and turned the fan to 'on'. Some time after my wife and I noticed the house was getting...
12-12-07, 08:08 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, Will do! Happy Holidays and a Happy and...

Jay,
Will do!
Happy Holidays and a Happy and Prosperous New Year to you and yours!
Paul
12-12-07, 07:43 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, All hooked up and running fine! A big...

Jay,
All hooked up and running fine!
A big THANK YOU for all your help!
Paul
12-11-07, 03:16 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, I found the HUM-H, but not the HUM-N. ...

Jay,
I found the HUM-H, but not the HUM-N. There are open tabs on the generic "LINE NEUTRAL" portion of the board. Is that where I make my other connection?
Thanks,
Paul
12-11-07, 06:36 AM
Replies: 38
Views: 9,158
Posted By pbro

Thank you...

Jay,
Thanks. I'll get the stuff I need and wire it up (hopefully) tonight. I'll post status back.
Thanks again,
Paul
12-10-07, 09:02 PM
Replies: 38
Views: 9,158
Posted By pbro

http://www.dnmech.com/lit/IO-242.pdf Page...

http://www.dnmech.com/lit/IO-242.pdf

Page 29.

Thanks! I'll pick this up tomorrow.
12-10-07, 07:54 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, What problem does wiring the circuit per...

Jay,
What problem does wiring the circuit per the mfg. schematics cause?

I'm assuming by your drawing that the outlet will be powered on when the furnace/blower fires?

Looking at the schematic...
12-10-07, 06:30 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, I've disconnected everything and will...

Jay,
I've disconnected everything and will 'hold'.

The humidifier will work when touching the yellows together.

I wired the circuit as shown in the link above (circuit diagram). Yellow from...
12-10-07, 06:07 PM
Replies: 38
Views: 9,158
Posted By pbro

Jay, Thanks for the reply. We must have been...

Jay,
Thanks for the reply. We must have been posting at the same time.

I got it done w/o the sail switch. I suspect the sail switch wasn't operating correctly for some reason.

Anyway...all...
12-10-07, 06:04 PM
Replies: 38
Views: 9,158
Posted By pbro

Problem solved...

I couldn't get the sail switch to operate properly but found the connections to the furnace, so now whenever the furnace pressure switch closes it completes the circuit and the humidifier fires right...
12-10-07, 01:58 PM
Replies: 38
Views: 9,158
Posted By pbro

Link to furnace wiring...

Here's a link to my furnace wiring. You can see the wiring diagram on page 29.

http://www.dnmech.com/lit/IO-242.pdf

Furnace model GMS80904BNA.

Thanks,
Paul
12-10-07, 08:30 AM
Replies: 38
Views: 9,158
Posted By pbro

Honeywell HE360A and sail switch wiring...

Good morning all!

I bought a HE360A with the accessory kit (sail switch, tubing, etc...) and hooked it up last night. I banged my head against the wall trying to figure out how the system is...
Replies: 2
Views: 898
Posted By pbro

Decking material help...

Hello everyone,
1st post! I look forward to finding great information and posting my experiences on this site.

I built a deck using a premium grade, severe weather decking surface end of May...
Showing results 1 to 18 of 18


 
Forum Jump