Search: Posts Made By: DenAlan
Showing results 1 to 12 of 12
Search took 0.01 seconds.
06-29-16, 07:02 PM
Replies: 1
Views: 511
Posted By DenAlan

AC and furnace not working

This past winter a builder moved my thermostat to another room as part of a remodel. The furnace worked fine. Now I try to put on the AC and it doesn't work. Neither does the furnace.

The circuit...
Replies: 2
Views: 491
Posted By DenAlan

That fixed it. I didn't see any debris but I blew...

That fixed it. I didn't see any debris but I blew it out and it works great now. Thanks for the advice.
Replies: 2
Views: 491
Posted By DenAlan

reduced flow irrigation system

i use city water for my irrigation system. All zones are good except one. The flow starts off pretty good but in 10 minutes has reduced to a dribble. I've checked all connections and sprinkler heads...
Replies: 2
Views: 394
Posted By DenAlan

Range shows error message

My GE range shows an error message of -F- and beeps constantly. It has been powered off for several months and now when I put on the power I receive the message. What is wrong?
Replies: 2
Views: 343
Posted By DenAlan

Refrigerator motor cycling

My Kenmore refrigerator motor cycles on very noisily and runs for only 5-10 seconds and then goes off. What is wrong?
Replies: 5
Views: 905
Posted By DenAlan

No, I couldn't spin it. I wound up using a punch...

No, I couldn't spin it. I wound up using a punch from inside the hole where I removed the knob and driving it out. Thanks for your reply.
Replies: 5
Views: 905
Posted By DenAlan

door latch removal

The door latch is not secured to the door with a plate and two screws. The door is metal and the latch is encircled by a round plate. How do I remove it from the door so I can install a new one?
Replies: 2
Views: 971
Posted By DenAlan

painting cement walls - not in basement

I am going to paint the cement wall in my daughter's apartment in China. They are on the second floor, not in the basement so moisture should not be a problem. the walls have been painted previously....
Replies: 1
Views: 1,105
Posted By DenAlan

Roof vent installation

My roofer did not install roof vents where they were previously located. He has shingled up to the last couple rows at the ridge. When I asked him about the missing vents he said he marked their...
Forum: Water Heaters
03-28-08, 10:21 AM
Replies: 4
Views: 1,298
Posted By DenAlan

When to replace water heater?

My water heater works great! But it was installed in 1981 and has a couple holes in the outside casing of the tank. I'm afraid it might spring a leak. Do I wait for it to stop working or start to...
Replies: 4
Views: 1,402
Posted By DenAlan

Pump doesn't shut off

It is a jet pump and is less than one year old.
Replies: 4
Views: 1,402
Posted By DenAlan

Pump doesn't shut off

My well pump doesn't shut off. The pressure guage on the tank builds up to about 30 lbs but goes no higher even though the pump continues to run. The pump, tank, and pipes become very hot. I put on a...
Showing results 1 to 12 of 12


 
Forum Jump