Search: Posts Made By: handyman18706
Showing results 1 to 25 of 54
Search took 0.01 seconds.
Replies: 4
Views: 1,304
Posted By handyman18706

1993 merc

it is a trim motor not the complete motor ,i ordered one ,but it is not the same numbers all match but cant see ho it will work
Replies: 4
Views: 1,304
Posted By handyman18706

trim motor

thanx i already did that ,but i am a novice working on outboards ,so i will buy a new one that i found for 255.00 thanx
Replies: 4
Views: 1,304
Posted By handyman18706

1993 75 hp merc

i am trying to find a way to rebuild my trim motor ,or find a place to buy a reasonable motor ,thanx
Replies: 3
Views: 981
Posted By handyman18706

braided line

i have bought numerous cutters none are good , whats the one i need
Forum: Water Heaters
03-10-14, 06:34 PM
Replies: 7
Views: 649
Posted By handyman18706

water heater

look into instant hwh or on demand expensive to first put in but will pay for itself
Replies: 3
Views: 1,029
Posted By handyman18706

i have both transmitters none work ,thanx

i have both transmitters none work ,thanx
Replies: 3
Views: 1,029
Posted By handyman18706

Unhappy motorguide remote elec motor

the motor will turn rt. and lft. but the prop will not start
10-19-12, 07:00 PM
Replies: 1
Views: 971
Posted By handyman18706

rough in

i have7 toilets and a urinal and 5 sinks what size waterline to feed everything i am using pexx
Replies: 3
Views: 1,555
Posted By handyman18706

sounds like you dropped a cap from anything you...

sounds like you dropped a cap from anything you have over your toilet
Replies: 3
Views: 756
Posted By handyman18706

swaying

i have a 17 foot bass boat and it sways as i am going down the road not a lot but sometimes it gets out of control i have to slow don and resume my speed
Replies: 5
Views: 4,078
Posted By handyman18706

oil leak

i have dealt with this problem for years, sometimes it is an afterburn , that is when the nozzle is too hot ,try cutting the nozzle down a size
Replies: 1
Views: 706
Posted By handyman18706

trim motor

i have a 75 hp merc. with a 1 ram trim , my trim works intermittenly, if i tap the trim motor it works fine for a while , what do i have to replace ?
Replies: 4
Views: 866
Posted By handyman18706

trim motor

thanx ,when the weather gets a little better i will try it , thanx again
Replies: 18
Views: 2,541
Posted By handyman18706

shut off heat

open flo valve and hit it with a hammer with the circ running , that usually works
Replies: 5
Views: 1,685
Posted By handyman18706

temp

whats the low limit ?make sure it is 20 degrees apart
Replies: 4
Views: 866
Posted By handyman18706

trim motor

i just bought the boat , when i tried to move the trim it did not work ,later it worked enough to take the bar off , now i get no response but i do hear a click.;by the way its a merc 75
Replies: 4
Views: 866
Posted By handyman18706

trim motor

i think my trim moter is bad, i have a 1993 starcraft bassboat with a 75 hp motor , how hard is it to change
Replies: 2
Views: 641
Posted By handyman18706

thanx i will try it

thanx i will try it
Replies: 3
Views: 3,135
Posted By handyman18706

ditto on the last reply replace the flapper too

ditto on the last reply replace the flapper too
Forum: Water Heaters
08-14-07, 07:35 PM
Replies: 3
Views: 886
Posted By handyman18706

replace the elements first they are cheaper

replace the elements first they are cheaper
Forum: Water Heaters
08-14-07, 07:30 PM
Replies: 4
Views: 1,110
Posted By handyman18706

the only difference with the warrantys , it is...

the only difference with the warrantys , it is the same heater but you pay for the warranty they are the same heaters
Forum: Water Heaters
08-14-07, 07:25 PM
Replies: 7
Views: 1,300
Posted By handyman18706

put an st 12 on the cold water line it will...

put an st 12 on the cold water line it will remedy your plbm
08-14-07, 07:19 PM
Replies: 1
Views: 1,107
Posted By handyman18706

have you recently painted i had the same plbm ...

have you recently painted i had the same plbm it was bad paint
08-14-07, 07:12 PM
Replies: 3
Views: 979
Posted By handyman18706

if you have a fluidmaster you will have that ...

if you have a fluidmaster you will have that you have a loose pipe somewhere put a ballcock that has a tank ball it will close slower
Replies: 2
Views: 3,645
Posted By handyman18706

qb 180

i have that plbm all the time the wires from the transformer are blocking the eye you have to be careful how you place the wires trial and error
Showing results 1 to 25 of 54
 


 
Forum Jump