Search: Posts Made By: edgil
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 6
Views: 974
Posted By edgil

Hour Meter Method

Thanks doughess,

I just in stalled a similar hour meter last week. I am looking to replace the house boiler and will use your recommended method to help determine the sizing. thanks again.
Replies: 6
Views: 974
Posted By edgil

Dope Slap

spott was correct, there is a 0.85 nozzle in place already, so my question was made mute. Thanks to spott & roughneck77 for your help and getting back so quickly.
Replies: 6
Views: 974
Posted By edgil

Changing nozzle size in hot water boiler

I have a 30 year old Peerless WB3 hot water boiler with a 1.1 gal per hour nozzle that is rated at 129,000 Btu gross output and 112,000 water Btu I did a whole house load calculation using the site...
Replies: 1
Views: 560
Posted By edgil

2003 Ford Ranger electrical issue

A week or so ago, after pulling my Ranger out of the driveway, notice that the radio would go off and on numerous times. This happened for 10 minutes and about 4 miles of driving. Finally realized...
Replies: 7
Views: 495
Posted By edgil

Thanks zoesdad, I got this response from...

Thanks zoesdad,

I got this response from spott along with my response. Thanks for your help

E,
You mentioned the burner motor reset so that time was obviously the motor but now you have a...
Replies: 7
Views: 495
Posted By edgil

spott, Thanks for getting back to me. As I was...

spott,
Thanks for getting back to me. As I was reading your response and deciding what to do next, I heard the blower motor kick on, but without the sound of a flame. Went down to basement to see...
Replies: 7
Views: 495
Posted By edgil

Thanks for getting back to me The unit was...

Thanks for getting back to me

The unit was last serviced Sept, 2015 with new nozzle, filter and ignition electrodes. The reset button on the burner blower motor did need to be reset once during...
Replies: 7
Views: 495
Posted By edgil

Intermittent boiler shut down

Oil boiler shut down over Thanksgiving Holiday while out of town. The manual reset button on the burner blower motor was out, so reset. The boiler started up and ran correctly. The burner blower...
Showing results 1 to 8 of 8


 
Forum Jump