Search: Posts Made By: Ace0Trades
Showing results 1 to 10 of 10
Search took 0.01 seconds.
04-13-20, 10:57 PM
Replies: 3
Views: 136
Posted By Ace0Trades

Need help wiring a receptacle with 3 pairs of wires.

Hello my fellow Handy People,

I hope everyone is doing well with their quarantine.

My friend was painting his room and took the outlets out and put them back, but now one outlet in the room...
Replies: 4
Views: 1,715
Posted By Ace0Trades

I want the light fixture to be lower from the...

I want the light fixture to be lower from the ceiling, and I have enough chain, but not enough wire to reach the wire in the ceiling from the desired length. If I extend the wire from the end then...
Replies: 4
Views: 1,715
Posted By Ace0Trades

Short Wire On Chain Light Fixture

What is the easiest solution for extending a wire on a chained light fixture without it looking bad, having wire nuts showing or diffrent colored wire attached together.
Replies: 5
Views: 640
Posted By Ace0Trades

Not the same light fixture

I Changed out a light fixture in the kitchen from fluorescent to LED that only had one black, white and ground wire coming out and connected each end of the socket to each wire, and when I left, my...
Replies: 5
Views: 640
Posted By Ace0Trades

Exclamation Ballast bypass in the kitchen: now chandler isn't working

I took the ballast out of a tube light fixture and replaced it with LEDs and the chandler next to it isn't working.
...
Replies: 13
Views: 972
Posted By Ace0Trades

wow wow wow, I knew I was right the whole time...

wow wow wow, I knew I was right the whole time with the circuit, I just didn't have the right bulbs, the guy at the store told me for sure they were bypass ones, but they weren't single side power. I...
Replies: 13
Views: 972
Posted By Ace0Trades

Yeah those diagrams are really helpful and I made...

Yeah those diagrams are really helpful and I made the circuit but it didn't work, do I have to have the side that isn't wired shunted?
Replies: 13
Views: 972
Posted By Ace0Trades

Circuit Setup

This is what I am working with here, I tried wiring it up the way it showed in the diagram and nothing is working for me. One thing I failed to mention is that I'm using a smaller gauge wire for the...
Replies: 13
Views: 972
Posted By Ace0Trades

Tube Type

I have the single side power tubes.
Replies: 13
Views: 972
Posted By Ace0Trades

Need help with ballast bypass. From fluorescent to LED.

I have an issue setting up LED lights in my light fixture which I remove the ballast out of and remove the wiring from one side, and connected two non-shanted holders on one side. One holder was 4...
Showing results 1 to 10 of 10


 
Forum Jump