Search: Posts Made By: Pluto9
Showing results 1 to 9 of 9
Search took 0.01 seconds.
06-27-19, 08:25 PM
Replies: 1
Views: 1,152
Posted By Pluto9

Block Combustion Air Intake for Summer?

Hi
Would it be ok to seal the outside air intake pipe leading into the furnace? Our wet spring weather has created allot of bugs so far this summer and I would like to keep the air intake pipe clean...
03-06-19, 10:21 AM
Replies: 16
Views: 653
Posted By Pluto9

Thumbs up The past few days have been cold in my area and...

The past few days have been cold in my area and so the wood fireplace smoke has picked up in the neighborhood, however, we are noticing much less smoke enterinng the house.

As mentioned in my...
03-04-19, 11:19 AM
Replies: 16
Views: 653
Posted By Pluto9

Last night was cold, -15c / 5 degrees. I checked...

Last night was cold, -15c / 5 degrees. I checked the basement windows and noticed cold drafts around the sliding frames. As a temporary measure I sealed the windows with tape, five windows in total....
03-02-19, 11:15 PM
Replies: 16
Views: 653
Posted By Pluto9

Now that I understand how a sealed combustion...

Now that I understand how a sealed combustion furnace functions, I think the problem of smoke entering the house is more likely coming from drafty windows, doors or bathroom exhaust vents. I'll...
03-01-19, 02:11 PM
Replies: 16
Views: 653
Posted By Pluto9

I took a picture of the burner area - the...

I took a picture of the burner area - the combustion air intake is just above the burners.
Is this considered a sealed system? Is this entire chamber area part of the sealed system?
02-28-19, 02:34 PM
Replies: 16
Views: 653
Posted By Pluto9

Outside Combustion Air

Hi,

A few months ago I had new gas furnace installed. 96% efficency / 80,000 btu.
The installer added a new direct vent pipe to the outside of the house for the combustion air intake. Since the...
10-25-18, 06:39 AM
Replies: 5
Views: 1,111
Posted By Pluto9

Thanks Akpsdvan for pointing me in the right...

Thanks Akpsdvan for pointing me in the right direction. I did some reading on John Guest fittings and believe this 90 angle valve part is a quick connect type fitting.

I found this Kinetico...
10-24-18, 10:18 AM
Replies: 5
Views: 1,111
Posted By Pluto9

unfortunately the warranty has expired

unfortunately the warranty has expired
10-22-18, 05:57 PM
Replies: 5
Views: 1,111
Posted By Pluto9

Softener Pressure Relief Valve Leak

Hi All,
I own a Kinetico Mach 2060s which has recenlty started to leak water from the pressure relief valve located above the pre-filter housing. The leak is coming from the valve housing that...
Showing results 1 to 9 of 9


 
Forum Jump