Search: Posts Made By: PAIN803
Showing results 1 to 25 of 29
Search took 0.01 seconds.
Replies: 1
Views: 117
Posted By PAIN803

Bath tub handle will not align straight

I have a Kohler bath tub handle in pictures below. The handle will not a line straight. It is one notch to the right or to the left.I am dong some thing really wrong. I have the pictures in the...
Replies: 1
Views: 163
Posted By PAIN803

I have 2015+2018EX CRV

I have two auxiliary power outlet (plugs for shone or kids stuff) in each car. For some reason 2 in one crv and one it the other crv are not working. I have changed the fuses in all three. I even...
Replies: 5
Views: 213
Posted By PAIN803

When the back sliding door is opened. A few...

When the back sliding door is opened. A few minutes later the alarm chirps a few times until I disarm. The screen then says --BACK SL DOOR TAMPER-. If I open any other circuit this does not happen. I...
Replies: 5
Views: 213
Posted By PAIN803

When I go to the display I do not see any thing. ...

When I go to the display I do not see any thing. All I see is a star,date and time. NO code. This happens when the sliding door is just open or even later on during the day. Plus only on this...
Replies: 5
Views: 213
Posted By PAIN803

Have a concord 4 series security system

MY back sliding door is wireless.. After my back door is open for a while the alarm starts chirping but not all the time. The only way to stop is to hit the disarm button. I have changed the battery...
04-20-20, 02:25 PM
Replies: 5
Views: 197
Posted By PAIN803

3/4 in ball valve sweat

I just installed a 3/4 ball valve sweat and it is leaking. It is leaking at the seam. Is there a way to fix it. I tried to tight in but no help.
Replies: 4
Views: 246
Posted By PAIN803

Predator 2014

The Predator generator is from 2014.The engine # RA20111. Brought in 2016. When you fill the gas tank the gas comes out of the carburetor I don't see how to shut off gas when carburetor is filled....
Replies: 4
Views: 246
Posted By PAIN803

Predator ar 2011

When I put gas in the generator it comes out of the carburetor. Not sure if this model has a float or not.
Replies: 2
Views: 276
Posted By PAIN803

Have a concord 4 series security system

I also have two ATP1000 KEYPADS. The touch pads started to beep a few times until I hit the disarm button and code to disarm. On the touch pads I am getting a P1 after the TIME. I tried to see what...
Replies: 3
Views: 242
Posted By PAIN803

That is what the main problem was, no neutral on...

That is what the main problem was, no neutral on one side of the light. In the original dimmer I took out the BLK wires did not go to any neutral. I had look a few times at the pictures I took. How...
Replies: 3
Views: 242
Posted By PAIN803

Wiring a dimmer

I had to change the double switch box with a three switch box, I had marked the wires but in old age I screwed up. I have a Lutron maestro MACL-153MLH-LA and a COMPANION LUTRON DIMMER. I have...
Replies: 2
Views: 178
Posted By PAIN803

75 watt no can recessed

Does Hallo make 75 watt no can recessed lights with baffle? All I find is 60 or 65 watt lights 6 or 4 in (either will be OK). I understand 65 and 75 is not much different but feel better having that...
Replies: 7
Views: 388
Posted By PAIN803

With the pitch of the roof I would like to try...

With the pitch of the roof I would like to try and use NO CAN LED 75 WATT LIGHTS (if wife likes the housing).I would be able to fish the wire after the hole is cut so I would not have to get all the...
03-05-20, 10:05 AM
Replies: 3
Views: 367
Posted By PAIN803

Can not adjust Hinges

Every since I brought this house this cabinet has been a problem.I would like to replace the hinge below. Would like a hinge that I would like to be able to adjust this cabinet Any ideas?
Replies: 3
Views: 315
Posted By PAIN803

Yes I did stir the paint. It is the only two...

Yes I did stir the paint. It is the only two gallon paint can that there is and it says CEILING paint on the side of the can. Why it turned gray I really do not know? Only use new brushes and never...
Replies: 3
Views: 315
Posted By PAIN803

Ceiling paint turned to a light gray

I purchased a two gallon ceiling paint and use part and closed it.When I closed it I use a piece of saran wrap and close the container good. I have been using saran wrap to close all paint can. If I...
Replies: 5
Views: 470
Posted By PAIN803

Yes there is a isolation valve about 6 in above...

Yes there is a isolation valve about 6 in above the tank.So then I will just drop tank out of my way. Once the tank is off I will check the tank pressure.
...
Replies: 5
Views: 470
Posted By PAIN803

Can I lower a pressure relief tank ?

I have a hot water base board system and radiant heat. I would like to lower the green tank about 2 ft. I need the space for a small manifold to heat bathroom floors.
08-04-19, 05:04 AM
Replies: 20
Views: 3,212
Posted By PAIN803

Thank you for the thought of mold. I do not have...

Thank you for the thought of mold. I do not have mold. As with any mold you can take you hand and it will come off a little. Even if hand was damp it will come off where ever it is. The word I...
Replies: 0
Views: 385
Posted By PAIN803

Disk of covering for out door lights

I had round disk on the bottom of some of my out door lights. The disk stopped bugs and moisture from getting down to the bottom of the light. What are they called?? I would like to order them.
08-02-19, 11:29 AM
Replies: 20
Views: 3,212
Posted By PAIN803

The bath room has no fan. There has never been a...

The bath room has no fan. There has never been a problem with MOLD. The medicine cabinet is recessed most of the way and about 1 in out of wall.
08-01-19, 07:55 AM
Replies: 20
Views: 3,212
Posted By PAIN803

All I want to do is seal the edges of the mirror....

All I want to do is seal the edges of the mirror. Between the kids and wife it looks like a steam room in the bathroom. I have had black on the edges of the mirrors a few times. I would like not to...
07-30-19, 11:51 AM
Replies: 20
Views: 3,212
Posted By PAIN803

Sealing bathroom mirror

I have read that you can use silicone on edge of mirror to seal it. I have also read you can not do this. Installing new bath room medicine cabinet. There will be some steam in the room. So what is...
11-23-15, 05:33 AM
Replies: 6
Views: 826
Posted By PAIN803

New electrical box and new cab

I was trying to figure out how to install new electrical outlet boxes. If I attach to the stud and then put the plaster board over that the box will not make it into cab wall. Would it be wrong to...
Replies: 5
Views: 615
Posted By PAIN803

The only problem with what you are saying is the...

The only problem with what you are saying is the other wall cab. I have cab with a wall oven and cab above Ref (icebox). How can you make the cab same height if you drop cab above counter top to 17...
Showing results 1 to 25 of 29
 


 
Forum Jump