Search: Posts Made By: N3kf99
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Replies: 1
Views: 738
Posted By N3kf99

Uniden dect1560 cordless phone system

I had a phone go bad and have 6 headsets registered to the base.i got a replacement, but can't register it since I can't clear out the phone from the base. Does anyone know how to factory reset a...
Replies: 14
Views: 2,467
Posted By N3kf99

This has the snap in speed control. You just bend...

This has the snap in speed control. You just bend the tabs to increase or decrease speed. Essentially does what you said. Running good. Thanks.
11-27-16, 05:36 PM
Replies: 8
Views: 657
Posted By N3kf99

Yes I meant soffit when I said eaves. Yes it was...

Yes I meant soffit when I said eaves. Yes it was agreed in a crude contract that the baffles were to be removed and reinstalled with the new sheathing. However, the law tests to what a "reasonable...
11-27-16, 02:30 PM
Replies: 8
Views: 657
Posted By N3kf99

Attic insulation and ventilation

I needed a new roof put on and my sheathing in the attic was covered with mold. So the sheathing was torn off and new sheathing put on. The roofer was suppose to put the air baffles back on the...
Replies: 14
Views: 2,467
Posted By N3kf99

Thank you cheese. That seemed to work. It seems...

Thank you cheese. That seemed to work. It seems like it might be running a little slow. I don't have a tach for a lawn mower. I assume I can adjust the speed a bit by adjusting the snap in speed...
Replies: 14
Views: 2,467
Posted By N3kf99

Thanks cheese. That is the way that it is set...

Thanks cheese. That is the way that it is set now. The governor is not working. As soon as you start mowing, the RPMs drop down. I know one of the two connections was in the bottom hole. And I...
Replies: 14
Views: 2,467
Posted By N3kf99

Every picture I have seen does not have the "snap...

Every picture I have seen does not have the "snap in speed control" that my engine has. The image shown here is different as it's a connection to a lever. Also, mine is set as the picture and the...
Replies: 14
Views: 2,467
Posted By N3kf99

I really need a side shot since the governor...

I really need a side shot since the governor lever has 4 holes in it. I guess I could try ask combinations, but that seems like a waste of time.
Replies: 14
Views: 2,467
Posted By N3kf99

This is a link to what the speed control looks...

This is a link to what the speed control looks like, but it does not show what the positions on the governor should be for the spring and linkage.
...
Replies: 14
Views: 2,467
Posted By N3kf99

Unfortunately, my linkage does not look anything...

Unfortunately, my linkage does not look anything like what that shows. Well, the carb linkage does, but my carburator has the speed control that mounts to the top of the carb which has a spring going...
Replies: 14
Views: 2,467
Posted By N3kf99

Lawn boy silver series governor

Some dummy (OK, me) replaced the carburator on my lawn boy. Unfortunately, I did it over a winter and thought I remembered the governor linkage, but did not. Yes, I know, take pictures. Sigh... It's...
Showing results 1 to 11 of 11


 
Forum Jump