Search: Posts Made By: mheitt
Showing results 1 to 10 of 10
Search took 0.01 seconds.
12-10-12, 06:27 AM
Replies: 6
Views: 4,177
Posted By mheitt

This may be a no-brainer for some of you, but can...

This may be a no-brainer for some of you, but can someone give me a quick tutorial on how to lubricate a blower motor?

And are there other (better) ways to clean a dusty motor other than using...
12-09-12, 01:01 PM
Replies: 6
Views: 4,177
Posted By mheitt

I've got Red, Blue, Black, White, Brown and Brown...

I've got Red, Blue, Black, White, Brown and Brown wires. First time I wired it up I connected white to white, black to red (for low speed) and both browns to capacitor. Then I wired it white to...
12-08-12, 07:23 PM
Replies: 6
Views: 4,177
Posted By mheitt

Blower Motor heating up and smelling burned

I just had my AC/Gas Furnace system replaced after 20 years (outside compressor was shot). When the installation guys were dragging away the old unit I asked them to pull the furnace's blower motor...
Replies: 12
Views: 6,996
Posted By mheitt

sorry

would like to see what you've done with it, but I'm sorry to say I don't know where you can get those parts. Ironically I have considered posting a question as I can't seem to get my tractor started...
Replies: 12
Views: 6,996
Posted By mheitt

Bigger Wheels and other Mods on this "Toy"

Yup... it's a toy, or perhaps an educational experience for my sons. Check out some photos at: http://picasaweb.google.com/mheitt/RacingMower

I'm particularly proud out the paint job (done for...
Replies: 12
Views: 6,996
Posted By mheitt

Bigger Wheels and other mods

Thanks guys. You're right that the key is 3/16" not a 1/4" (according to my service manual). Here's a link for the parts:...
Replies: 12
Views: 6,996
Posted By mheitt

Bigger Wheels for old Craftsman Rider

I'm hoping to upgrade to larger rear wheels for an old, previously junked and salvaged Craftsman Riding Mower (502.254172). Stock wheel parts number is 91632E601. They fit onto a slotted/square...
Replies: 3
Views: 1,585
Posted By mheitt

perfect... thanks! can i be reasonable...

perfect... thanks!

can i be reasonable assured that if i find one of those sprockets on-line that it will 1) have a geared core rather than smooth or slotted, and 2) that it will fit using the...
Replies: 3
Views: 1,585
Posted By mheitt

i need a sprocket!

I'm hoping to replace the 8-tooth sprocket (#786047) off of an old, almost-junked Craftsman 502.254172 riding mower with a 10- or 12-tooth sprocket. See part 19 at...
Replies: 1
Views: 1,006
Posted By mheitt

i need a sprocket!

I'm hoping to replace the 8-tooth sprocket (#786047) off of an old, almost-junked Craftsman 502.254172 riding mower with a 10- or 12-tooth sprocket. See part 19 at...
Showing results 1 to 10 of 10


 
Forum Jump