Search: Posts Made By: Cinci-Hal
Showing results 1 to 25 of 32
Search took 0.01 seconds.
Replies: 10
Views: 346
Posted By Cinci-Hal

A Skid Steer / Bobcat can get back there, just...

A Skid Steer / Bobcat can get back there, just not a truck, so a concrete buggy would work.
Replies: 10
Views: 346
Posted By Cinci-Hal

Question Pouring Footing with no large equipment access

I want to to pour footings for a 8" CMU crawl space foundation wall, but there is no access for large equipment to the area. From the closest access point to the far reaches of the project is about...
Replies: 5
Views: 1,349
Posted By Cinci-Hal

How about a traditional forced air gas furnace...

How about a traditional forced air gas furnace and AC unit that allows LP conversion? what is the smallest size those come in? I have only seen as small as 40,000 BTU units, but I would only need...
Replies: 5
Views: 1,349
Posted By Cinci-Hal

Question HVAC for a Tiny (352 sq.ft.) house

I did't see a category for some general HVAC questions, so I'm posting my questions here hoping they can be answered (I'm open to not just gas heaters). I am designing a tiny house that has an...
02-09-17, 02:03 PM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

I think all your answers were very helpful....

I think all your answers were very helpful. Thanks so much for your input.
02-09-17, 01:03 PM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

I'm assuming it can be recessed in the wall, but...

I'm assuming it can be recessed in the wall, but can you place something over the panel door like hang coats over it (behind the front door is where I plan to hang coats) or place a picture over it?
02-09-17, 12:58 PM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

That information is very helpful! Thank you...

That information is very helpful!
Thank you very much!
02-09-17, 12:21 PM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

Thank you! That is very helpful. Are there any...

Thank you! That is very helpful. Are there any restrictions in the room? I think I read somewhere that it cannot be located in a bathroom, bedroom or closet. I believe this was the same place that...
02-09-17, 12:14 PM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

Ideally, I would be anchoring it to the ground...

Ideally, I would be anchoring it to the ground and doing whatever else is needed to have it qualify as a residence under the tiny house appendix of the IRC. My understanding is that mobile homes...
02-09-17, 09:48 AM
Replies: 15
Views: 1,253
Posted By Cinci-Hal

Question Electrical for Tiny House on Wheels

I am designing a Tiny House On Wheels (THOW) that I am planning to build and am wondering what the electrical requirements are. Mainly, at this point I am trying to decide where I can put the...
01-10-17, 04:44 PM
Replies: 3
Views: 10,458
Posted By Cinci-Hal

Question Is there such a thing as a propane powered Mini split system?

I am designing a tiny house on wheels and am looking for the best way to heat and cool it. This tiny house will be approximately 22'L. x 7'W. x 10'-9"H inside, with min. of 3 1/2" closed cell spray...
12-31-16, 06:33 PM
Replies: 6
Views: 4,831
Posted By Cinci-Hal

Yes, I thought that might be true after I posted...

Yes, I thought that might be true after I posted it. Thank You!
12-31-16, 01:03 PM
Replies: 6
Views: 4,831
Posted By Cinci-Hal

Is something like this drawing correct?

Is something like this drawing correct?
12-31-16, 07:51 AM
Replies: 6
Views: 4,831
Posted By Cinci-Hal

Question How does one show three switches on a floor plan?

I need to show a lighting diagram on a floor plan, but I'm not sure how. I want to show three switches to a light source and am not sure if they should all be designated as 4-way switches and I'm not...
10-17-15, 04:38 AM
Replies: 1
Views: 526
Posted By Cinci-Hal

Question How practical are solar panels on an east & west facing roof?

Just wondering about how practical it would be installing solar panels on a roof in the Midwest (Southern Ohio, for example) where the gable roof faces east and west? And what would be acceptable...
Replies: 1
Views: 803
Posted By Cinci-Hal

Question Poured concrete basement wall form sizes?

Trying to get an idea of what standard sizes are for poured concrete basement wall forms, in both widths and heights, so that when designing a basement wall, or any stem wall for that matter, it...
07-20-13, 09:40 AM
Replies: 4
Views: 3,611
Posted By Cinci-Hal

Question What size skid steer for moving dirt, removing patio, and digging up stump

I am thinking of renting a skid steer to do some landscaping. the main thing I want to do is excavation. I also have a couple of stumps I would like to remove. They are from 12"diam. and 14"diam....
Replies: 2
Views: 4,566
Posted By Cinci-Hal

I have a wall to wall row of wall cabinets with...

I have a wall to wall row of wall cabinets with toekick below my dining room window. the 15" deep counter top is on top of that. It will be used mainly to set decor on top, but may be used as a...
Replies: 2
Views: 4,566
Posted By Cinci-Hal

Question How to paint wood countertop

I have a wood countertop and need to know what the best method for painting it would be. I have primed and sanded the surface with oil based primer and have attempted to paint with Rustolium biscuit...
Replies: 2
Views: 1,546
Posted By Cinci-Hal

Question Filling in spots over oil based primer on wood

I need to fill in low spots on a poplar wood countertop that has had Behr brand oil based primer sealer applied to it. I have applied several coats of the primer sealer and after letting it cure for...
Replies: 3
Views: 1,154
Posted By Cinci-Hal

There is one top that will need to be trimmed...

There is one top that will need to be trimmed down in the back, and I had that made a little deeper as well. I am putting tile on the back wall, so countertops were fabricated without splashes. It...
Replies: 3
Views: 1,154
Posted By Cinci-Hal

Question Trimming a little off laminate countertop

I am installing laminate countertops in my kitchen. I already have the tops and had them made a little long so I could trim (sand, plane or other) them to the correct profile of the walls. I'm...
11-01-09, 06:42 PM
Replies: 4
Views: 978
Posted By Cinci-Hal

Question Finding laminate countertop fabricator

I would like any tip on finding a company that can make up some laminated countertops that I will install myself. It seems like all the companies that are listed, when I google "laminate countertops"...
Replies: 1
Views: 533
Posted By Cinci-Hal

Question replacing 48" florescents with recessed cans

I currently have, in the middle of a 9' x 14' kitchen with 8' ceiling, a ceiling light fixture with two 48" florescent bulbs. I would like to replace this with recessed cans. Would it be safe to say...
06-20-09, 01:37 PM
Replies: 3
Views: 782
Posted By Cinci-Hal

There is a bare copper wire that is larger than...

There is a bare copper wire that is larger than 10 gage, maybe 8 0r 6 gage, that goes from the breaker box to a water pipe about 20 feet away. There is a smaller, 16 gage I think, bare copper wire...
Showing results 1 to 25 of 32
 


 
Forum Jump