Search: Posts Made By: TryAgain
Showing results 1 to 11 of 11
Search took 0.06 seconds.
09-05-20, 10:23 AM
Replies: 8
Views: 264
Posted By clocert

Hope your system is running OK, just to remember...

Hope your system is running OK, just to remember your thermostat has a 3-5 minutes delay feature, your outside condenser also have a 3-5 minutes delay feature. that is may be where the 8 minutes come...
09-04-20, 10:35 PM
Replies: 8
Views: 264
Posted By PJmax

Most thermostats have delays built into them....

Most thermostats have delays built into them. Some systems also have a delay. It could be up to at least 5 minutes for the outside condenser and inside blower to start.

You have a heat pump...
09-04-20, 06:40 PM
Replies: 8
Views: 264
Posted By Tolyn Ironhand

A capacitor "charges" as soon as voltage is...

A capacitor "charges" as soon as voltage is applied to it. As soon as the unit turns on it has all the "charge" it needs.

You should test the microfarads (UF) of the cap to see if it is still...
Replies: 15
Views: 523
Posted By WML13

Tryagain, I ran into a carb similar to yours that...

Tryagain, I ran into a carb similar to yours that not only had a steel pin that acted to stop the fuel flow, but a composite material washer that acted as a valve seat for the needle on the tip of...
Replies: 15
Views: 523
Posted By marbobj

With the float (white horse shoe shaped thing)...

With the float (white horse shoe shaped thing) hanging down, you should be able to blow through the inlet. That's the path gas takes to get into the float bowl to run the engine.
Replies: 15
Views: 523
Posted By marbobj

Turn the part in the picture down and blow in the...

Turn the part in the picture down and blow in the fuel inlet. If you can't get air through it the float valve is either stuck or plugged.

Don't be sticking stuff down the inlet tube. You might...
Replies: 15
Views: 523
Posted By cheese

Take the bowl off the carburetor and visually...

Take the bowl off the carburetor and visually verify a steady strong stream of gas flowing through the inlet needle. Not just a trickle but a flow. Sounds like your fuel flow is not enough to keep up...
Replies: 15
Views: 523
Posted By Pilot Dane

I'm guessing your coil is bad. Get tools and...

I'm guessing your coil is bad. Get tools and gloves at hand to remove the spark plug. Run the engine until the engine dies. Then quickly remove the spark plug (wear gloves because it will be hot)....
Replies: 15
Views: 523
Posted By Tony P.

Gas caps are often the cause of mower stalling...

Gas caps are often the cause of mower stalling but the backfiring is an indication of a different issue. The backfire could be caused by the carb.being set too lean so perhaps you can adjust it.
...
Replies: 7
Views: 1,318
Posted By pugsl

I had to get several different carbs for small...

I had to get several different carbs for small engines this year. All have had the parts on them that did not come off.One had the choke lever on backward and they sent me a new one and did not want...
Replies: 7
Views: 1,318
Posted By shellx

Those carbs are relatively inexpensive. get the...

Those carbs are relatively inexpensive. get the briggs engine # and go to amazon!
Showing results 1 to 11 of 11


 
Forum Jump