Search: Posts Made By: Greatdollymama
Showing results 1 to 16 of 16
Search took 0.01 seconds.
Replies: 5
Views: 733
Posted By Greatdollymama

I sure hope rebuilding is to code is possible! I...

I sure hope rebuilding is to code is possible! I took it apart in pieces and it is all sitting in the yard. I guess, worst case, I can put it back on and just replace the worst parts and call it a...
Replies: 5
Views: 733
Posted By Greatdollymama

Locally we have to conform to IRC 2009. Still not...

Locally we have to conform to IRC 2009. Still not sure what I need to comply with. It is on the roof of the garage, a deck was there that I just removed, to have a new roof surface installed. The old...
Replies: 5
Views: 733
Posted By Greatdollymama

Building code for rooftop deck

Hello everyone,
Can any of you point me in the direction of the building codes for rooftop decks? I have found the code for decks in general, but does not seem to offer anything specific for...
Replies: 23
Views: 2,887
Posted By Greatdollymama

you said you had a intake gasket replace, for a...

you said you had a intake gasket replace, for a leak? did the miss fire start after the intake gasket replacement? if so I would guess there is a leak. does the car try to die at idle but run fine at...
Replies: 21
Views: 1,623
Posted By Greatdollymama

Most transmission advice will be vehicle...

Most transmission advice will be vehicle specific. Some transmissions have screens, some have filters, some filters are external, some are internal, some fluids are meant to last 100,000 miles or...
04-13-16, 12:11 PM
Replies: 8
Views: 842
Posted By Greatdollymama

How exciting to have such a large garden area set...

How exciting to have such a large garden area set up for you! I also vote for pulling all the unwanted plants out and tilling. Covering with plastic will "kill" the plants above ground and may make...
04-13-16, 12:00 PM
Replies: 8
Views: 1,116
Posted By Greatdollymama

Just about any kind of oil will work to remove...

Just about any kind of oil will work to remove adhesive. I would use plan old cooking oil in this case, talk about the inexpensive route. But you will have to do a secondary cleaning with soap and...
04-13-16, 11:52 AM
Replies: 4
Views: 4,612
Posted By Greatdollymama

That is a cool chart, Zorfdt.

That is a cool chart, Zorfdt.
Replies: 15
Views: 1,125
Posted By Greatdollymama

Originally from the switch (where the power is)...

Originally from the switch (where the power is) they had a 3 wire bx cable. they were using one wire for the light and one for the load beyond the light with only one common. I pulled out the old and...
Replies: 8
Views: 977
Posted By Greatdollymama

If you change your mind and want to go the...

If you change your mind and want to go the refinish route. Talk to the used car manager at your dealer, they for sure know a guy that does wheel refinishing. Typically he is mobile and comes to the...
Replies: 15
Views: 1,125
Posted By Greatdollymama

I guess, I really knew the answer the whole time....

I guess, I really knew the answer the whole time. I was just hoping there was a "trick". Oh well why not add a little wall repair to my list of things to do. ( :wall: may or maynot have been how that...
Replies: 15
Views: 1,125
Posted By Greatdollymama

the light fixture is in between the switches...

the light fixture is in between the switches though. it is a old house and pulling new cable is very tricky.

i think what you are saying is that i need to run an additional wire for the other...
Replies: 15
Views: 1,125
Posted By Greatdollymama

ok, so both my switches are in place and the...

ok, so both my switches are in place and the light is working from both switches. the circuit beyond the light works as long as the switch where the power comes in at is "on". the light itself can be...
Replies: 15
Views: 1,125
Posted By Greatdollymama

Stickshift You are correct adding an...

Stickshift

You are correct adding an additional switch.
Replies: 15
Views: 1,125
Posted By Greatdollymama

yes it worked before. and i understand that the...

yes it worked before. and i understand that the traveler wire has to be installed along with the wiring to the 2nd - 3 way switch. Working on adding the additional switch currently. as typical hind...
Replies: 15
Views: 1,125
Posted By Greatdollymama

installing a 3 way switch with power to switch

Hello,
I am trying to install a 3 way switch at an exsisting light with single switch. Power comes into the original switch to the light, but then passes the light on to another light and outlet. I...
Showing results 1 to 16 of 16


 
Forum Jump