Search: Posts Made By: Tolyn Ironhand
Showing results 1 to 10 of 10
Search took 0.01 seconds.
09-12-20, 12:13 PM
Replies: 7
Views: 352
Posted By PJmax

That is not a wives tail. If the water moves too...

That is not a wives tail. If the water moves too fast it leaves the solids behind.
Replies: 10
Views: 248
Posted By pugsl

Be sure to get the no finger print finish, I had...

Be sure to get the no finger print finish, I had one finger prints were impossible to remove.
Forum: Water Heaters
09-06-20, 06:05 AM
Replies: 11
Views: 377
Posted By AllanJ

Find the two wires in the wall box that go to the...

Find the two wires in the wall box that go to the water tank. Label their connection points in the box and remove just those two wires.

Do not touch anythinng else in the box.

Run the new water...
09-05-20, 09:50 AM
Replies: 15
Views: 486
Posted By cwbuff

Here are some pictures of the wire that was under...

Here are some pictures of the wire that was under the metal staple. I pounded these staples about as hard as I could with a 16 oz hammer. What appears to be exposed conductor on the white wire is...
Replies: 14
Views: 800
Posted By Dixie2012

I skipped through & read some posts but I havent...

I skipped through & read some posts but I havent read every post in this thread so I may pass on irrelevant or double post info.

I have a 2007 Dodge Ram 1500 4X4 Off Road with the 5.7 Hemi & tow...
09-05-20, 08:59 AM
Replies: 33
Views: 787
Posted By CasualJoe

I would suggest you go a step further and install...

I would suggest you go a step further and install an intersystem bonding bridge and get that cable ground wire off the meter socket.
Arlington | Intersystem Grounding Bridges...
09-03-20, 01:02 PM
Replies: 15
Views: 486
Posted By cwbuff

A very interesting topic. Anyone who has...

A very interesting topic. Anyone who has installed staples has probably missed the staple and hit the cable and left wondering if you caused any damage. After reading some conflicting stuff on the...
04-30-20, 04:29 AM
Replies: 23
Views: 796
Posted By pcboss

I would have used 1900 boxes and raised covers...

I would have used 1900 boxes and raised covers instead of the handy boxes. Not enough room.
06-12-19, 09:15 AM
Replies: 5
Views: 523
Posted By CasualJoe

Actually, MCA means Minimum Circuit Ampacity. An...

Actually, MCA means Minimum Circuit Ampacity. An MCA of 28 amps means the circuit must be rated at minimum for 28 amps. The next largest circuit would be 30 amps so #10 wire would be used for the...
06-08-19, 07:21 AM
Replies: 6
Views: 624
Posted By AFJES

I believe if it is a double pole switch it would...

I believe if it is a double pole switch it would have "On" and "Off" imprinted on the switch itself. If it is a 4 way it will not have the imprint as the 4 way could be on or off up or down depending...
Showing results 1 to 10 of 10


 
Forum Jump