Search: Posts Made By: moory
Showing results 1 to 9 of 9
Search took 0.01 seconds.
02-18-19, 12:22 PM
Replies: 11
Views: 1,296
Posted By moory

is this unit was operating in the last two month?...

is this unit was operating in the last two month?
check the filters that are cleaned n no obstructions in the air flow.
No water in the pressure switches hoses n the water drain is clean with no...
02-09-19, 12:01 AM
Replies: 3
Views: 558
Posted By moory

Ensure the pressure switch is closing....no water...

Ensure the pressure switch is closing....no water in line.
02-08-19, 11:15 PM
Replies: 8
Views: 599
Posted By moory

All I can tell this is very ugly installation.......

All I can tell this is very ugly installation.... check the manufacturer manual for the equipment n call back your installer and teach him to read the manuals prior to attempt any installation.
02-08-19, 11:09 PM
Replies: 18
Views: 778
Posted By moory

it sounds like your prayers finally saved you.......

it sounds like your prayers finally saved you.... the furnace is working again. Helelojia 🙂🙂🙂.
02-08-19, 10:56 PM
Replies: 7
Views: 696
Posted By moory

And the culprit is........

After checking the vent over the roof that has no restrictions then Aha... I found a permanent filter in the air inlet before the blower fan. how come I didn't see it before, I have no idea how did I...
02-08-19, 02:22 AM
Replies: 7
Views: 696
Posted By moory

Getting close to fix

First , thanks PJ max, your answer yesterday about the pressure switches lights a light bulb in front of me, yes it's two stage furnace with double pressure switches and water condensation...
02-06-19, 10:15 PM
Replies: 7
Views: 696
Posted By moory

I got code "14" gas valve lockout , (wait 3 hrs...

I got code "14" gas valve lockout , (wait 3 hrs to reset)..one day before all that, which is yesterday, the furnace runs ok until the temp reaches 61 deg then disconnect on gas valve lockout....I...
02-06-19, 09:16 PM
Replies: 18
Views: 778
Posted By moory

Do you have a picture of the wiring diagram?

what is the model of this unit and the manufacturer?
02-06-19, 09:10 PM
Replies: 7
Views: 696
Posted By moory

Bryant furnace with ignitor problem

I got Bryent furnace plus 90i that its ignitor doesn't glow while it does glow under self diagnostic test. Does the ignitor in series with the pressure switches?
Showing results 1 to 9 of 9


 
Forum Jump