Search: Posts Made By: jafrtr
Showing results 1 to 11 of 11
Search took 0.01 seconds.
09-10-14, 08:53 AM
Replies: 15
Views: 9,597
Posted By jafrtr

I'm thinking about a 50amp breaker in my main...

I'm thinking about a 50amp breaker in my main panel...then running single pole wires.. then a 30 amp breaker at sub panel to plug. In future can just replace 30 with 50 or wire direct to the plug.
09-10-14, 08:49 AM
Replies: 15
Views: 9,597
Posted By jafrtr

liking the Single conductor idea...could go with...

liking the Single conductor idea...could go with 4 or 6 gauge?....would you pull 4 wires for future 50 amp 120v...or get away with 3 and use neutral as the ground?
09-10-14, 08:43 AM
Replies: 15
Views: 9,597
Posted By jafrtr

Is SER 2-2-2-4 inside ok then junction to.... "...

Is SER 2-2-2-4 inside ok then junction to....
" Southwire’s Quadruplex URD used for secondary distribution and underground service. It can be used for direct burial or in ducts." ....2-2-2-4
...
09-10-14, 08:16 AM
Replies: 15
Views: 9,597
Posted By jafrtr

Yeah. I am going to do a 30 amp now...a 50 if I...

Yeah. I am going to do a 30 amp now...a 50 if I get a different RV down the road. Just planning on what type of wire. May have to go with a UF 6/3...although more expensive. Just seeing if there are...
09-09-14, 11:46 AM
Replies: 15
Views: 9,597
Posted By jafrtr

I could put in 2 pole 50 amp for future 120/240...

I could put in 2 pole 50 amp for future 120/240 use.
09-09-14, 11:43 AM
Replies: 15
Views: 9,597
Posted By jafrtr

Only need 120 volt....I may go with a 50 amp...

Only need 120 volt....I may go with a 50 amp breaker. My current RV takes 30 amp. Option of using this cable in conduit? Just looking for cheapest way to make a run of 175', 80 feet inside/ basement,...
09-09-14, 09:13 AM
Replies: 15
Views: 9,597
Posted By jafrtr

2-2-2-4 Aluminum SER Service Entrance Cable

2-2-2-4 Aluminum SER Service Entrance Cable .....
Can I use this cable for dedicated 30 amp 175' run from my home service panel to an RV?
Replies: 7
Views: 2,489
Posted By jafrtr

Wiring

In the crate from the factory, the supply 120 line was connected to the C1 and C 2. The blower was connected to the L1 and L 2 as it should have . That was the problem. Wired incorrectly from...
Replies: 7
Views: 2,489
Posted By jafrtr

system diagram

had main circulator on return. I put in two pumps on send. With the main circulator firing on TT demad and the selected zone pump as well, caused both zones to circulate. Now with return pump...
Replies: 7
Views: 2,489
Posted By jafrtr

The beckett aquastat was wired wrong...pump in line?

I found wiring diagram (added insert) as to the factory installed aquasmart module. The wiring was not correct. I took supply line off of terminals and wired it accoding to diagram, it worked. You...
Replies: 7
Views: 2,489
Posted By jafrtr

Cool beckett aquasmart not working, new boiler

I installed a new boiler, a peerless pscii NG unit. running a Taco 3 circulator controller with two zones. I know all wiring is complete and correct. Problem is this: the Beckett aquasmart unit,...
Showing results 1 to 11 of 11


 
Forum Jump