Search: Posts Made By: B&DGurnee
Showing results 1 to 25 of 44
Search took 0.01 seconds.
Replies: 3
Views: 1,561
Posted By B&DGurnee

Thanks Pilot Dane, I was going to die thread...

Thanks Pilot Dane,
I was going to die thread the stake and with your recommendation of welding the tuna can I think it will work. Thanks for your help.
Replies: 3
Views: 1,561
Posted By B&DGurnee

Summer Torches

I hope this is the correct forum to post this.

I am trying to build some summer torches to stick in the ground using mostly materials I have. I have collected almost 20 clear wine bottles with...
01-08-10, 01:13 PM
Replies: 5
Views: 3,462
Posted By B&DGurnee

Thanks SPDavid and XSleeper for your comments. I...

Thanks SPDavid and XSleeper for your comments. I ended up buying a door sweep and a solid piece of oak. I cut the piece of oak perfectly to the empty space in the threshold as the rest of it was in...
01-04-10, 08:52 AM
Replies: 5
Views: 3,462
Posted By B&DGurnee

I was hoping that wasn't the answer. I searched...

I was hoping that wasn't the answer. I searched all over the piece for a brand to no avail. I thought maybe it was scratched off and I could find a part of a name or serial but nothing. I...
01-03-10, 05:39 PM
Replies: 5
Views: 3,462
Posted By B&DGurnee

Aluminum Threshold Weather Strip?

Hello,
Our Door to our garage has an aluminum threshold under it. There was a plastic piece in the middle, right under our door that was about an inch thick and ran across the whole strip. This...
Replies: 2
Views: 5,244
Posted By B&DGurnee

Adding Antifreeze to Refrigerator

Hello,
We have a 1978 Frigidaire that runs pretty well. The only problem is, when it kicks on, it makes this crazy slow engine noise. It can mostly be described as the sound of the didgeridoo...
05-04-09, 04:33 PM
Replies: 2
Views: 1,930
Posted By B&DGurnee

Any tips for drying out Carpet?

Hello,
I know this may be fruitless but I thought I would try. Last week our Hot water went out and leaked badly. It did not submerge my carpet but it is underneath it. You can feel it when you...
Replies: 1
Views: 1,153
Posted By B&DGurnee

Kenmore Replacement Ice Maker

Hello
I have a Kenmore Refrigerator. Model # 363.9742814. We bought this fridge used and it did not have an ice maker in it. The line has been run in the back and into the freezer but no ice...
Replies: 3
Views: 9,815
Posted By B&DGurnee

Hey thanks guys. Yes the height is going to be...

Hey thanks guys. Yes the height is going to be close. It is for a Northwoods cabin where the ceilings are pretty low. I will have to check that first but thank you much for your advice.
Replies: 3
Views: 9,815
Posted By B&DGurnee

Installing a ceiling fan with a drop ceiling

How do you install a ceiling fan in a room with a drop ceiling? Is there an extension bar I can attach to the junction box and fan? If this has been discussed already could someone post a link to...
Replies: 3
Views: 895
Posted By B&DGurnee

Thank you for your reply Chandler. That is...

Thank you for your reply Chandler.

That is what I thought when I first tackled this. Although when I connect the lines like that the new fixture will not turn off. The track lighting turns on...
Replies: 3
Views: 895
Posted By B&DGurnee

Wiring Confusion for one ceiling ligth and one track lighting

I am trying to install a light in a previously covered up junction box. When we finished our basement we couldnt decide on what type of fixture to install at the bottom of the stairs. We have track...
02-03-08, 07:35 AM
Replies: 1
Views: 1,635
Posted By B&DGurnee

Furnace power has to be turned on and off to restart furnace.

Hello,
We have a Carrier Furnace Model#58PAV090. About a month ago we realized our furnace did not come on after the next cycle. After some checking, Filters, Thermostat, we realized that by...
Replies: 4
Views: 3,967
Posted By B&DGurnee

Can I remove Safe T Beam on Genie Intellicode?

I have a Genie Intellicode that all of the sudden started acting up. It stops 4 inches from the ground and goes back up. I have mastered the rhythm and it goes as this. Open and close three times,...
Replies: 5
Views: 1,109
Posted By B&DGurnee

Carving a very large hole

I am trying to build a large sawdust bowl out of a Birch tree log. After every project I finish, I sweep up and throw away all of the sawdust on the floor. I was thinking I could use this sawdust...
08-06-07, 05:01 PM
Replies: 2
Views: 1,489
Posted By B&DGurnee

New Lennox Air Conditioning unit

Our A/C just started freezing up. The main coil started freezing at the condensor and then froze all the way up to our furnace. Our techinician said we were leaking oil into teh condensor and that...
07-26-07, 01:45 PM
Replies: 2
Views: 1,079
Posted By B&DGurnee

Thank you so much. hopefully i can help and do...

Thank you so much. hopefully i can help and do my part to bring this fern off the endangered list and into abundance.
07-26-07, 12:06 PM
Replies: 2
Views: 1,079
Posted By B&DGurnee

Sweet smelling fern?

hello
every once in awhile when i pass a forest or some shrubbery i will get a hint of a sweet smell. Someone once told me it was a fern. is this possible? it is an incredibly beautiful sweet...
Replies: 2
Views: 1,087
Posted By B&DGurnee

Hanging a mirror

I recently refinished our bathroom at the request of my wife. The old bathroom had a single, large mirror in front of a double sink countertop. The dimensions of the mirror are roughly 4 feet tall...
Replies: 2
Views: 3,195
Posted By B&DGurnee

3 Way Dimmer wiring problems

Hello. I recently removed two 3 way light switches in my bathroom and was going to install two 3 way Dimmers. When I removed the switches I noticed the wiring was different from one box to the...
Replies: 1
Views: 928
Posted By B&DGurnee

Old Shower Valve new Faucet

I recently refinished my shower and left the shower valve exposed. I purchased a new shower faucet, bet when I opened teh package I realized the Valve is a completely different design. It is a...
09-13-06, 04:57 PM
Replies: 3
Views: 1,212
Posted By B&DGurnee

thank you so much!! that was exactly what I was...

thank you so much!! that was exactly what I was looking for.
09-13-06, 04:20 PM
Replies: 3
Views: 1,212
Posted By B&DGurnee

Laying Marble Tile in a shower

I have a couple questions regarding laying marble tile in a shower. Can I use Mortar instead of Mastic? I have used Mastic in the past and found that it didnt hold as well as the Mortar I mixed...
07-09-06, 10:21 AM
Replies: 1
Views: 1,165
Posted By B&DGurnee

Cutting Marble Tile

Hello I am refinishing my bathroom tub with Marble Tile but I have never worked with marble before. I have laid Ceramic tile many times and I have my own wet saw. Will my wetsaw cut the Marble...
06-01-06, 10:28 AM
Replies: 5
Views: 1,017
Posted By B&DGurnee

That was a thought but there is about thirty to...

That was a thought but there is about thirty to forty stalks so I was hoping to find a different option.
Showing results 1 to 25 of 44
 


 
Forum Jump