Search: Posts Made By: pjaffe
Showing results 1 to 8 of 8
Search took 0.02 seconds.
Replies: 13
Views: 503
Posted By pjaffe

look at this similar US product. It is extremely...

look at this similar US product. It is extremely simple and I am guessing, similar to what yours looks like under that cover.

spring latch...
12-31-20, 11:39 AM
Replies: 7
Views: 185
Posted By pjaffe

I am pretty sure that if you extend the wire you...

I am pretty sure that if you extend the wire you need to leave that junction accessible. That means splicing a new length of wire and leaving the junction box behind a removable plate or cover....
Replies: 7
Views: 250
Posted By pjaffe

No expert here but I would charge up the battery...

No expert here but I would charge up the battery and then let it sit for a little while. Check the charge on the battery at that point without the truck running. It should be just over 12v. Turn...
Replies: 6
Views: 286
Posted By pjaffe

As long as you are running the ethernet cable to...

As long as you are running the ethernet cable to the second floor, I would take a different approach and buy a decent wifi router. That will give you strong wifi and the ability to hardwire with no...
Replies: 9
Views: 943
Posted By pjaffe

All of the above may be correct about the...

All of the above may be correct about the original installation. However, if it just started to act like this then perhaps the latch is worn and needs to be replaced. If you disassemble the handles...
06-03-20, 11:30 AM
Replies: 5
Views: 535
Posted By pjaffe

The red valve knob is the main gas shutoff. When...

The red valve knob is the main gas shutoff. When it is turned as it is in the picture so that it aligns with the direction of the pipe, then the gas is on. If you turn it (probably just 90...
Replies: 6
Views: 644
Posted By pjaffe

how about using an Echo Dot from Amazon with a...

how about using an Echo Dot from Amazon with a headphone jack to an audio-in port on your hifi system? Some adapter may be needed (maybe 3.5mm to 1/4"?)

- Peter
08-23-19, 09:08 AM
Replies: 4
Views: 922
Posted By pjaffe

I see two options. You can just wipe some...

I see two options. You can just wipe some linseed oil over that divot and consider it character. If you don't like the fact that its not smooth, maybe consider pouring some clear epoxy in the hole...
Showing results 1 to 8 of 8


 
Forum Jump