Search: Posts Made By: boowoo
Showing results 1 to 25 of 36
Search took 0.01 seconds.
06-27-13, 10:16 AM
Replies: 1
Views: 2,336
Posted By boowoo

Pentair minimax 100 ignition lockout

I recently posted. I have power to the system. I see that there is a spark to the ignitor for 4 seconds while I hear gas going to manifold. No pilot light. I must turn thermometer switch to midway to...
06-24-13, 02:13 PM
Replies: 4
Views: 3,233
Posted By boowoo

Got it. I will replace that, and hopefully it...

Got it. I will replace that, and hopefully it will fire up. Thanks a lot. I guess this cleanout needs to be done every year, prior to starting the heater. Much appreciated.
06-24-13, 11:53 AM
Replies: 4
Views: 3,233
Posted By boowoo

I can see through the blades of the exchanger....

I can see through the blades of the exchanger. But still no fire up of the burner. The unit inside is completely clean of debri (except the insulation on the sides of the exchanger). It is not even...
06-24-13, 09:06 AM
Replies: 4
Views: 3,233
Posted By boowoo

Pentair Minimax 100 Pool Heater

I have a Pentair Minimax 100 Pool Heater. It is the first time for the year getting above-ground pool open. I initially opened valves for gas (it is not plugged into power outlet) both outside on...
05-07-13, 04:55 AM
Replies: 8
Views: 2,201
Posted By boowoo

Thanks. Will do. I let it drip into a container...

Thanks. Will do. I let it drip into a container lastnight, and it produced a total of 42 ounces over a period of 9 hours.
05-06-13, 06:53 PM
Replies: 8
Views: 2,201
Posted By boowoo

I have no manual. It was installed by a local...

I have no manual. It was installed by a local company, when the house was built.
05-06-13, 06:46 PM
Replies: 8
Views: 2,201
Posted By boowoo

Are you referring to pressure coming into the...

Are you referring to pressure coming into the house, or from the cold water line valve that goes to the pre filter? We had in the area (neighborhood) a hydrant flush.
05-06-13, 06:18 PM
Replies: 8
Views: 2,201
Posted By boowoo

Unknown, but I have city well water coming to the...

Unknown, but I have city well water coming to the house. The regular water (after softener) is real good output. No noticeable change at all.
05-06-13, 05:36 PM
Replies: 8
Views: 2,201
Posted By boowoo

low output on whole home reverse osmosis system

I have a system with a pre and post filter, an NFX-19 holding tank, a membrane Filmtec TW30-1812-50 w/ cartridge holder that has a check valve on the output going to the input of the shut-off valve,...
Replies: 5
Views: 2,704
Posted By boowoo

Well, replaced thermostat. Still gets hot with...

Well, replaced thermostat. Still gets hot with low coolant light and flag showing overtemp. But going down road low coolant light goes out. And puddle of anti freeze with steam billowing from under...
Replies: 5
Views: 2,704
Posted By boowoo

A small drip on the ground. No white smoke or...

A small drip on the ground. No white smoke or sweet smell. But what is causing the "low coolant light to extinguish after reaching a certain temperature?
Replies: 5
Views: 2,704
Posted By boowoo

1991 Chevy Lumina sedan 3.1L Multi Port FI

I have a problem with rough starting until the engine gets warmed up (guage on dash increases in temperature). As it finally gets warmer the engine stabilizes (still in park mode), but temperature...
01-10-12, 07:36 AM
Replies: 10
Views: 2,070
Posted By boowoo

How do I remove old posts? And your right. But...

How do I remove old posts? And your right. But the Appliance store says that this, sensor is compatible, which I don't believe either.
01-10-12, 07:31 AM
Replies: 10
Views: 2,070
Posted By boowoo

Getting new gas range

Wondering if I need a new gas line flex hose? I am replacing the old gas range with a new range. Or can I re-use the old flex hose?
12-29-11, 09:45 AM
Replies: 10
Views: 2,070
Posted By boowoo

Same/replaceable part? Whirlpool 8053344 - AP2023670 - WB21X5301A Oven sensor

I have a GE Range JGSP31GER1WG, and I replaced the original sensor with a Whirlpool 8053344 sensor. Are they compatible, in ohms at room temperature? Is this the right sensor, and is the WB21X5301A...
12-25-11, 02:43 PM
Replies: 10
Views: 2,070
Posted By boowoo

I got the new oven sensor and I ohm'ed it prior...

I got the new oven sensor and I ohm'ed it prior to installation (1260 ohm's, just like the old sensor). Installed, and ran "bake" function at 400 degrees, and when it initially started to heat it was...
12-22-11, 09:33 AM
Replies: 10
Views: 2,070
Posted By boowoo

Thank you for the response and advice. I ordered...

Thank you for the response and advice. I ordered a WB21X5301 oven sensor, and hopefully this will resolve the issue. If not, then I am out of luck since they do not make the control board anymore and...
12-20-11, 02:33 PM
Replies: 10
Views: 2,070
Posted By boowoo

GE Oven Sensor for Model JGSP31GER1WG Oven

Ohm'ed out oven sensor at room temperature (disconnected cable from wire that leads to oven control board) and got 1269 ohm's. 1100 should be the reading at room temperature. Is the oven sensor bad?...
12-20-11, 09:10 AM
Replies: 10
Views: 2,070
Posted By boowoo

Jgsp31ger1wg ge gas range

Ohm'ed out oven sensor at room temperature (disconnected cable from wire that leads to oven control board) and got 1269 ohm's. 1100 should be the reading at room temperature. Is the oven sensor bad?
12-15-11, 08:20 AM
Replies: 10
Views: 2,070
Posted By boowoo

Model JGSP31GER1WG GE Oven Broiler timer question and oven sensor problem

When I place the broiler in "High" the timing is 17 seconds of flame, then 3 minutes of "off" time. This is the cycle. Is the broiler set to a internal temperature that controls the on/off of the...
Replies: 2
Views: 2,059
Posted By boowoo

Thanks

Thanks Pugsl. Wow! That sure impacts in comparison to all the other water delivery devices in the house.
Replies: 2
Views: 2,059
Posted By boowoo

Maytag Washer Model LAT8840AAW water tub/use per load capacity

Can anybody direct me to a site, or info me on how much water is utilized in a maximum load of washing from this washing machine, please? I read the average washer uses 45 gallons per load, but I'm...
Replies: 3
Views: 1,567
Posted By boowoo

Slight pitting on garage concrete floor (20 years of salt/water/snow)

I have slight concrete pitting on the floor of my attached garage. Mostly where the tires of the vehicles are. I have owned this place for 20 years when I had it constructed, and they used a sealer...
Replies: 10
Views: 2,558
Posted By boowoo

Thanks everyone.

I replaced the wheel bearing w/ sensor. It has been a week and not lights on the dash. Solved the problem. Thanks a bunch. Saved me and the family a few dollars in the household.
Replies: 3
Views: 605
Posted By boowoo

Just did mine in the front

I just did mine on my Buick Rendezvous. It took about 2 hours (mostly trying to break the axle nut loose with the socket/breakers bar). Real easy to do. I went to Advance Auto (they loan the sockets...
Showing results 1 to 25 of 36
 


 
Forum Jump