Search: Posts Made By: xexman44
Showing results 1 to 25 of 29
Search took 0.01 seconds.
06-24-14, 02:06 PM
Replies: 3
Views: 828
Posted By xexman44

Thanks for the ideas. I almost want to go to a...

Thanks for the ideas. I almost want to go to a big tank like a 20 gallon instead of just putting on a 5 or 6 gallon tank. Any sense doing that or is it overkill? I will check into the different...
06-23-14, 01:04 PM
Replies: 3
Views: 828
Posted By xexman44

Wrong size tank on lawn sprinkler pump?

Just bought a house that has it's own well for the lawn sprinkler system. The pump has a 2 gallon pressure tank on top of the pump.
A 3 zone system, each zone runs one at a time. When 2 of the zones...
02-27-11, 11:28 AM
Replies: 4
Views: 1,842
Posted By xexman44

Not sure how far that 4 inch pvc pipe runs....

Not sure how far that 4 inch pvc pipe runs. Started leaking last year. Thought I fixed it with that hydraulic cement last year. Came back again when the snow melted this year. I can't imagine what it...
02-26-11, 05:33 PM
Replies: 4
Views: 1,842
Posted By xexman44

pvc pipes leaking where they come through the cement floor

I probably didn't explain that right..my pvc pipes that come from my well pass through a 4 inch plastic pipe in the floor. I filled the hole as far down as I could with that hydraulic type cement....
Replies: 4
Views: 6,863
Posted By xexman44

I took all the tips off, pulled the wire out, fed...

I took all the tips off, pulled the wire out, fed it through again. It only binds up right at the handle. Works perfectly feeding the wire all the way through, until the wire hits the handle, then...
Replies: 4
Views: 6,863
Posted By xexman44

Those are some great ideas, I will give it a try...

Those are some great ideas, I will give it a try and see how it goes. Always seems so simple once you stop and think about it.
Are you a pilot too? Fun life isn't it?
Thanks and I will let you know...
Replies: 4
Views: 6,863
Posted By xexman44

Lincoln 135 won't feed wire

I have a Lincoln SP-135T mig welder that has worked perfectly until today. The drive wheel just spins but won't feed any wire through. I have half a roll of .035 left that has been feeding perfectly....
06-22-09, 04:34 PM
Replies: 7
Views: 4,118
Posted By xexman44

The green wire is hooked up to the thermostat and...

The green wire is hooked up to the thermostat and there is no power to it. It is cut down in the basement and even if I connect the two cut green wires, there is no power to it. I need to go into the...
06-20-09, 06:31 PM
Replies: 7
Views: 4,118
Posted By xexman44

Hunter thermostat problems

Hi Guys,
I have a Hunter 44260 thermostat. Works great on heat and a/c. My problem is I am trying to just turn on the fan to circulate some air without turning on the a/c unit. I traced the green...
Replies: 3
Views: 687
Posted By xexman44

tape

Yes I did remember to do that. Just amazing that everything thinks it is working but no ink comes out at all, not a drop, any color. You forget how worthless a computer is without a printer after...
Replies: 3
Views: 687
Posted By xexman44

Installed CIS system now printer will not print

Epson RX580. I installed a continuous ink flow system, printer says everything is fine, computer says everything is fine but no ink comes out of the heads. I tried cleaning them several times, ran...
Replies: 3
Views: 7,400
Posted By xexman44

great info

Thank you both for the info. I went ahead and ordered the whole gear set, does look easier, hopefully worth the extra money.
Great site, a real lifesaver.
Thank you sincerely for the help.
Joe B
Replies: 3
Views: 7,400
Posted By xexman44

Master Mechanic opener parts?

Hi Guys,
I have a Master Mechanic 1/2 HP Model 501MM that has a stripped gear. I am trying to find a replacement set of gears for it but can't find that particular model number anywhere. Is there...
Replies: 4
Views: 1,202
Posted By xexman44

ok, gotcha

No, there were no other openers in the garage, sorry about that.
I'll search for another circuit board then, easy to find and buy?
Thanks for the help with this.
Joe B
Replies: 4
Views: 1,202
Posted By xexman44

good questions

I have one remote on my Harley that sits in the garage. The other two are on my other vehicles. They have worked perfectly until just a few weeks ago.
I checked and there is not anything else...
Replies: 4
Views: 1,202
Posted By xexman44

Remote only works within 5 feet of opener

I have a Craftsman 1/2hp garage door opener. I used to be able to open it from 50 feet away. Now it only opens when I am less than 5 feet from the opener. I changed batteries and even the one in my...
Replies: 11
Views: 18,642
Posted By xexman44

might be it

It works fine today once the house warmed up. I guess there is a temperature differential switch in there somewhere and if it gets too cold, it just won't work. Can't let that happen again!
Thanks
Replies: 11
Views: 18,642
Posted By xexman44

too cold for the freezer to work?

I just got home from a 4 day trip and the temperature in my house was at 45 degrees for the whole time. My freezer has defrosted and the fridge doesn't seem cold enough to save the food either.
Was...
Replies: 5
Views: 12,019
Posted By xexman44

that changes everything

So it means changing a check valve down in the pump area? That bites the big kahuna doesn't it? I'll check into what it takes to get that fixed then. The system is 20 years old, I guess I've done...
Replies: 5
Views: 12,019
Posted By xexman44

still leaks

I shut off the water right after the pump so no water was running anywhere. Still leaks, really slow but still the pressure bleeds off. Is it worth taking the tank apart to change the check valve or...
Replies: 5
Views: 12,019
Posted By xexman44

Wellsaver tank slowly loses pressure

I have a Wellsaver LPT20 tank. Pressure switch is set correctly and works fine. My question is: after the pump cuts out, I can watch the pressure slowly bleed off the gauge when there is no water...
Replies: 2
Views: 902
Posted By xexman44

never mind

I found another solution. Toto makes a low pressure flush that will hook right up to my wall mounted toilet and do the job.
Any thoughts on how good the Toto flush valves work?
Replies: 2
Views: 902
Posted By xexman44

Wellxtroll wx-104 needed

I need a wx-104 pressure tank to fix my toilet problem and I am having a very hard time finding that particular item. Does anybody know where I can get one or order one? Or any other companies...
Replies: 7
Views: 7,041
Posted By xexman44

Thanks for the ideas guys. The separate tank...

Thanks for the ideas guys. The separate tank might do the trick. It would be cheaper than buying a whole new wall mounted toilet, they don't give those things away.
The Sloan valve is the 3.5 gal...
Replies: 7
Views: 7,041
Posted By xexman44

After doing some more research, another snag is...

After doing some more research, another snag is that I am on a well, not city water. My tank operates between 30 and 50psi. thats why it is enough for the liquids but not enough for the solids I...
Showing results 1 to 25 of 29
 


 
Forum Jump