Search: Posts Made By: sjc6793
Showing results 1 to 25 of 26
Search took 0.01 seconds.
Replies: 5
Views: 1,042
Posted By sjc6793

Why would that be?

Why would that be?
Replies: 2
Views: 755
Posted By sjc6793

There is any number of things. Start with the...

There is any number of things. Start with the coolant level. Move on to the thermostat, a t-stat stuck open will cause a heater to be warm at best. Like I said, with the info you have...
Replies: 5
Views: 1,042
Posted By sjc6793

The right outer cv boot is torn open. I work for...

The right outer cv boot is torn open. I work for a Ford dealer, this is one of our used cars, hate tearing into something without more then good intentions.
Replies: 5
Views: 1,042
Posted By sjc6793

2005 Ram 4wd Front Axle

I need to replace the front right axle on a 2005 Ram 1500 4wd. Should I be separating the spindle at the top or bottom? I am concerned about the torsion bar suspension. Any tips would be appreciated.
Replies: 2
Views: 2,042
Posted By sjc6793

Many times on rear wipers, the arm itself is not...

Many times on rear wipers, the arm itself is not fully attached to the motor. If the arm is held on by a nut (there may be a plastic cap covering it) the nut might be loose. If you are hearing the...
Replies: 1
Views: 716
Posted By sjc6793

Looking at the picture, it looks a lot like an...

Looking at the picture, it looks a lot like an interior temp sensor. Do you have automatic climate control? Meaning, electronic control, digital fan control etc? I am certain it is not part of the...
Replies: 1
Views: 522
Posted By sjc6793

Yes they did design it that way. Just pull the...

Yes they did design it that way. Just pull the stiff, carpeted trim back. You will find nuts holding the tail light in place. Its not that big a deal really.
11-30-07, 06:21 PM
Replies: 8
Views: 908
Posted By sjc6793

Outdoor Outlets

I read recently that it is against code to tap into a bathroom circuit for an outdoor outlet. According to the article, it ok to tap into a bedroom circuit but never a kitchen, bath or utility room....
Replies: 5
Views: 963
Posted By sjc6793

You didnt say if it was electronic temp control...

You didnt say if it was electronic temp control or not. If you have electronic control, the control unit could have gone bad. When you change the temp from warm to cold can you tell any difference at...
11-24-07, 07:45 AM
Replies: 2
Views: 809
Posted By sjc6793

Switched Outlet

I have installed two outlets outdoors. One is recessed in the exterior wall of the house. The other is on the same circuit going to the front yard planting area. They are both GFCI with the proper...
11-23-07, 02:03 PM
Replies: 8
Views: 1,646
Posted By sjc6793

I cannot believe nobody has asked why she dumped...

I cannot believe nobody has asked why she dumped it down the toilet.
Replies: 4
Views: 975
Posted By sjc6793

Power Steering Line

I used to replace a lot of those. There really is no EASY way to do it. It is much like a game of twister, I am only half joking on that one. The pressure and return line are connected together with...
Replies: 4
Views: 2,405
Posted By sjc6793

Tempo Windows

First thing to try, get some spray silicone or even WD-40. At the front and back of the glass is a guide. It is the black rubber or cloth like track the glass slides in. Spray the guide from the top...
Replies: 1
Views: 1,318
Posted By sjc6793

Explorer

The fact that you notice an RPM change with no speed change, sounds like the transmission. The transmissions around that year for the Explorer had problems.
One trait that I have noticed with them,...
Replies: 1
Views: 692
Posted By sjc6793

Intrepid Windows

It sounds like the window "guides" are too dry. I cant remember if Intrepid windows actually have a window frame. Meaning, when you open the door, is there a steel frame around the window. Spray some...
Replies: 1
Views: 970
Posted By sjc6793

Tensioner

Many of those tensioners have left hand threads on the bolt holding the pulley on. Put the socket on that nut and try turning it both ways to see if that releases tension.
Replies: 1
Views: 762
Posted By sjc6793

Computer restoring itself???

Running windows xp. Twice in the last 2 months it has somewhat restored itself to an earlier setting. I have lost my favorites, my desktop goes to a blue screen. Any documents I might have saved are...
Replies: 2
Views: 3,062
Posted By sjc6793

Blower Motor

Replace the blower motor resistor. It should be under the dash on the passenger side near the blower motor itself.
Replies: 1
Views: 755
Posted By sjc6793

Part Suppliers

I am having trouble locating parts to go from the ductiing to the vent register. For example I want to go from a 6 inch round to a square register. Its somewhat of an older home that used a round...
Replies: 5
Views: 4,774
Posted By sjc6793

Crown Vic Turn Signals

When you turn the hazard lights on, grab the button and wiggle it. Do the same thing when you try to use the turn signals. The multi function switch ( that is essentially the entire lever and push...
10-29-07, 07:51 PM
Replies: 5
Views: 1,396
Posted By sjc6793

Garage Wiring

The garage is attached. I have already run a 100 amp sub-panel to the garage. This panel will feed a dedicated 15 amp circuit for a fridge. A 15 amp circuit for lighting in the laundry area, as well...
10-29-07, 06:29 PM
Replies: 5
Views: 1,396
Posted By sjc6793

Garage Outlets

I am rewiring my garage, I would like it to be up to code because I do plan to sell in a few years. I have read that code (California) calls for GFCI outlets in a garage. I am planning roughly 4...
04-10-07, 03:05 PM
Replies: 2
Views: 1,176
Posted By sjc6793

Gas Line Unions

If teeing off a black gas line, can a union be used? It is 45 feet from the building shut off. From there it is 20 feet from the appliance it will be servicing.
Replies: 1
Views: 770
Posted By sjc6793

Suppliers

Can anyone recommend a good online supplier of duct pieces and/or registers. The local big box store does not have a very good selection.
04-09-07, 02:13 PM
Replies: 1
Views: 1,168
Posted By sjc6793

Gas Line Code

I want to make sure my plans will meet code. I am planning to tee off the black gas line going to my furnace. It will be in the closet where the furnace is located. I will be using a union to make...
Showing results 1 to 25 of 26
 


 
Forum Jump