Search: Posts Made By: Eric Fullerton
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Replies: 5
Views: 2,814
Posted By Eric Fullerton

I made one

I just laid a circle of plywood over my tank about the size of the intended lid, Tied up some rebar for strength, in case it ever needed lifted & included some lifting loops of rebar. Used the dirt...
Replies: 5
Views: 443
Posted By Eric Fullerton

I'm contented for now, it cuts on and off...

I'm contented for now, it cuts on and off smoothly, I got my original wish, it is now chest high and easy to service, I put in a new switch so it should be good for a while. I probably will put a...
Replies: 5
Views: 443
Posted By Eric Fullerton

Reporting back; What I first tried did not work,...

Reporting back; What I first tried did not work, as the switch would pulse several times both on cut in and cut out. That was no doubt bad for the controller and pump. I moved it to the other side of...
Replies: 5
Views: 443
Posted By Eric Fullerton

Thank you for the prompt reply, that resembles...

Thank you for the prompt reply, that resembles what I'm plumbing. there will be another T below it as I'm also including an eye level gauge. For now I will just abandon the old switch, shouldn't hurt...
Replies: 5
Views: 443
Posted By Eric Fullerton

Mount pressure switch up high

Just a quick question, I'm planning to replace the pressure switch on my
deep well, (5hp, a little over 400') . Is there any reason it needs to be at the base of the pressure tank? I have a maze of...
Showing results 1 to 5 of 5


 
Forum Jump