Search: Posts Made By: superskid
Showing results 1 to 25 of 27
Search took 0.01 seconds.
Replies: 2
Views: 551
Posted By superskid

OK, that's an easy test. I will do that and...

OK, that's an easy test. I will do that and report back. Middle of winter here is that going to affect my results?
Replies: 2
Views: 551
Posted By superskid

Putting down Vinyl flooring in garage

I have purchased this vinyl flooring to install in my garage:
...
Replies: 3
Views: 1,228
Posted By superskid

Slatwall direct over insulation and vapor barrier

One of the walls in my garage is insulated and vapor barriered, but there is no drywall, the rest of the garage (other walls and ceiling) are drywalled as well but not taped.

I want to install...
08-27-15, 01:39 PM
Replies: 5
Views: 657
Posted By superskid

If it did it's up against the fridge where it...

If it did it's up against the fridge where it would never be seen. The fridge sticks out past the opening. I just want the easiest way to get it in there.
08-27-15, 01:33 PM
Replies: 5
Views: 657
Posted By superskid

Not yet as I am at work and just being relayed...

Not yet as I am at work and just being relayed the information, but from the sounds of things it is the other side that is bowed, and that is up against a granite counter so not sure what I can do...
08-27-15, 01:28 PM
Replies: 5
Views: 657
Posted By superskid

Fridge space quarter inch too small

I got a replacement fridge under warranty that I was told is the same size, but it doesn't fit where the old one did. If I measure the fridge I get 36", if I measure the space where the fridge is to...
Replies: 2
Views: 1,277
Posted By superskid

I swapped out the whole unit, only piece I reused...

I swapped out the whole unit, only piece I reused is the close limit sensor. I don't think it's a short on the button, for 2 reasons.

1) The car remotes do the exact same thing

2) Too much of...
Replies: 2
Views: 1,277
Posted By superskid

Garage door won't open after close limit switch is triggered

I just changed out the motor of my garage door opener, thinking that the circuit board was the problem. Original problem thread:
...
Replies: 1
Views: 7,778
Posted By superskid

Need to unplug and plug back in garage door opener for it to work

For some reason I need to unplug my garage door opener from the wall and plug it back in for any of the remotes, keypad, or even the wall button to work. As soon as I power reset it all of these...
10-03-13, 08:08 PM
Replies: 4
Views: 1,462
Posted By superskid

maybe cheaper, but likely still more then I want...

maybe cheaper, but likely still more then I want to spend on this project
10-03-13, 03:13 PM
Replies: 4
Views: 1,462
Posted By superskid

Need another 15" clearance in basement

I am looking at putting a golf simulator into my basement, but unfortunately I need another foot to be able to swing my driver safely. My ceilings are 8 feet now and a 9 foot ceiling would be...
12-17-07, 11:47 AM
Replies: 36
Views: 2,686
Posted By superskid

Thanks for the follow up. Actually the day I...

Thanks for the follow up. Actually the day I went to unhook the return line I noticed that there was some frost building up on the windows upstairs. (It was really cold out -30 C)

Since then...
12-01-07, 02:34 PM
Replies: 36
Views: 2,686
Posted By superskid

OK, it's outside under the deck I think, but I...

OK, it's outside under the deck I think, but I should be able to get to it.
12-01-07, 02:15 PM
Replies: 36
Views: 2,686
Posted By superskid

Recess lights? Upon further inspection it...

Recess lights?

Upon further inspection it looks as though there IS another fresh air line that goes into the ductwork. It runs parallel to that other line that goes into the metal screen, but...
12-01-07, 02:07 PM
Replies: 36
Views: 2,686
Posted By superskid

Hi Jay, I have no idea what that metal thing...

Hi Jay,

I have no idea what that metal thing on the end is. All I know is that the air coming out of it is freezing cold. In fact there is some frost on the metal mesh. I thought that there...
12-01-07, 01:32 PM
Replies: 36
Views: 2,686
Posted By superskid

Hi Jay, I have not yet disconnected the...

Hi Jay,

I have not yet disconnected the fresh air line, but I have taken a couple of pictures. One of my install, and the other of what I believe to be the fresh air line. (freezing cold air...
11-28-07, 05:32 PM
Replies: 36
Views: 2,686
Posted By superskid

Hi Jay, I have the UPM thermostat that I...

Hi Jay,

I have the UPM thermostat that I mentioned earlier.

If the humidifier is sized OK I guess I will disconnect the fresh air line? Is there any harm in this? If not why is it there in...
11-28-07, 11:13 AM
Replies: 36
Views: 2,686
Posted By superskid

My thermostat doesn't tell me, but I am guessing...

My thermostat doesn't tell me, but I am guessing when I heat the house (only during the evening) it runs for 20 min an hour or so.

Will upgrading to the next size Honeywell do anything given that...
11-27-07, 09:18 PM
Replies: 36
Views: 2,686
Posted By superskid

I will tap into the hot water tomorrow and see if...

I will tap into the hot water tomorrow and see if that makes any change.

I guess I will look up what I want the indoor humidity to be at for minus 20. It is at 27% now but still feels pretty dry.
11-27-07, 08:51 PM
Replies: 36
Views: 2,686
Posted By superskid

Any suggestions then on getting the humidity up? ...

Any suggestions then on getting the humidity up?

Will wiring it up to run not only when the heat is on help?


I assumed that I wanted the indoor humidity at 40% regardless of temp. Outside...
11-27-07, 08:14 PM
Replies: 36
Views: 2,686
Posted By superskid

1.) Have not seen any sign of frost or humidity...

1.) Have not seen any sign of frost or humidity on any of the windows.

2.) 7 hours since midnight last night. (I assume, when I press the usage button on the thermostat it says that is how long...
11-27-07, 07:51 PM
Replies: 36
Views: 2,686
Posted By superskid

Hey Jay, I have had this unit installed...

Hey Jay,

I have had this unit installed since the date of my last post, but the indoor humidity fails to get above 33% (usually hovers around 27%) despite me having it set to 45%

It seems to be...
11-13-07, 09:30 AM
Replies: 36
Views: 2,686
Posted By superskid

Picture looks great. I think I have the wiring...

Picture looks great. I think I have the wiring figured out.

Last step, I assume by valve you just mean connecting to the unit itself. The actual winter/summer valve is done by hand, correct?
11-13-07, 07:50 AM
Replies: 36
Views: 2,686
Posted By superskid

Hi Jay, I can't quite make out the photo. ...

Hi Jay,

I can't quite make out the photo. If you could get a better quality shot that would be great.

Thanks,
11-12-07, 08:31 PM
Replies: 36
Views: 2,686
Posted By superskid

Sorry Jay, I'm not too sure what this means....

Sorry Jay,

I'm not too sure what this means. Any chance there is a picture of what I need and where it goes, thanks.
Showing results 1 to 25 of 27
 


 
Forum Jump