Search: Posts Made By: Briggsman
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 7
Views: 3,644
Posted By Briggsman

Since is rotational and seems to correspond...

Since is rotational and seems to correspond cyclically to each wheel rotation, i would suspect a small rock chip stuck in one of the brake dust shields. I've seen them before where the noise can be...
Replies: 7
Views: 733
Posted By Briggsman

Check codes and see if any are stored. If...

Check codes and see if any are stored.

If no faults, verify fuel pressure (when problem is occurs)

A quick way to verify fuel pressure is to depress the schredder valve. It will be somewhere...
Replies: 7
Views: 733
Posted By Briggsman

volt stability refers to the voltage regulator...

volt stability refers to the voltage regulator built internally in the alternator. 12.5v is a bit low. if the engine cranks at regular speed but will not start, it's not a battery/alternator issue. ...
Replies: 19
Views: 1,288
Posted By Briggsman

1/2 of the other end is encased in concrete (hard...

1/2 of the other end is encased in concrete (hard to see in picture). Should I chisel the concrete around it?49276 I don't want to damage to pipe.
Replies: 19
Views: 1,288
Posted By Briggsman

The p trap travels diagonally to the top right of...

The p trap travels diagonally to the top right of the zoomed out picture, not much room until it goes under the foundation. It is not encased in cement, however the cement becomes jagged with not...
Replies: 19
Views: 1,288
Posted By Briggsman

Not good news. It looked like it would be...

Not good news. It looked like it would be threaded as it had a hex fitting. I'm glad I didn't try to hard to get it to turn. Is this something a master plumber would be able to handle? This maybe a...
Replies: 19
Views: 1,288
Posted By Briggsman

finally got to 2" pipe

I have dug all the way down to the P trap, where thankfully the p trap appears to be 2". Problem is There is a threaded hex connection that connects the 1-1/2" pipe to the 2" P trap. Its way down in...
Replies: 19
Views: 1,288
Posted By Briggsman

I've been following How to Fit a Shower Tray...

I've been following How to Fit a Shower Tray (http://www.familyhandyman.com/bathroom/shower-installation/plumb-install-a-shower-base/view-all) on installing the shower base.

It states "Most shower...
Replies: 19
Views: 1,288
Posted By Briggsman

The piece pictured does accept the tub drain and...

The piece pictured does accept the tub drain and overflow pipe. There is around a 12"x12" area cut out in the slab where the pipe goes. If I continue digging will I be able to reach the main drain...
Replies: 19
Views: 1,288
Posted By Briggsman

Sink Drain used as a shower drain, should I dig it out?

I am installing a shower base where a tub/shower used to be. I've got the old tub out and am working on the plumping for the new shower base. I've found
that the previous installer used a sink...
Showing results 1 to 10 of 10


 
Forum Jump