Search: Posts Made By: RichNHS
Showing results 1 to 21 of 21
Search took 0.01 seconds.
02-07-09, 11:20 AM
Replies: 6
Views: 1,406
Posted By RichNHS

OK... furnace fan runs and ramps up as...

OK... furnace fan runs and ramps up as needed...no problem here.

TrueSTEAM functions in the 25-2 setup selection of the TrueIAQ settings (if you read this in your copy of the manual to be the...
02-07-09, 07:48 AM
Replies: 6
Views: 1,406
Posted By RichNHS

Furnace fan is set to run 24/7 in the "ON"...

Furnace fan is set to run 24/7 in the "ON" position.

All "dip switches" are in the down (off) positions.
02-07-09, 07:31 AM
Replies: 6
Views: 1,406
Posted By RichNHS

Correct... G from Tstat to GT on TrueSTEAM and G...

Correct... G from Tstat to GT on TrueSTEAM and G from furnace to GF on TrueSTEAM.

Wired per instructions from Honeywell book :confused:
02-06-09, 12:48 PM
Replies: 6
Views: 1,406
Posted By RichNHS

Question Honeywell TrueIAQ default setting function issue

The "setup" function (default) for #25 shows a setting of 1=Hum only while fan on for Humidifier Operation. Problem I have is that the TrueSTEAM won't run at that default setting? It will run on...
01-30-09, 08:30 AM
Replies: 33
Views: 3,763
Posted By RichNHS

MJBXX..Main floor about 1500sf...18' ceiling...

MJBXX..Main floor about 1500sf...18' ceiling familyroom / foyer part...master suite vaulted...DR & Kit/Dinette 10' ceilings. Three BRs upstairs are closed off and on separate furnace when needed...
01-29-09, 09:00 PM
Replies: 33
Views: 3,763
Posted By RichNHS

But 60 degrees colder with lots of snow/ice...:D ...

But 60 degrees colder with lots of snow/ice...:D But at least your humidifier works and mine is still a work in progress. 35 - 38 % humidity is all I've noted thus far...with my wiring correct I'm...
01-29-09, 04:35 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Last time I checked the power light was on, after...

Last time I checked the power light was on, after I was instructed to "reset" and it appears as though it is not steaming as my humidity level remains under 40 % and doesn't seem to move up. I'll...
01-29-09, 10:12 AM
Replies: 33
Views: 3,763
Posted By RichNHS

Jay... I have my settings on the IAQ just as you...

Jay... I have my settings on the IAQ just as you suggested. On the TrueIAQ I have installed, the top 2-pins are labeled as "R" & "C" and not as 24v as noted on page 12 in the owners guide. My guess...
01-28-09, 08:00 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Jay...I will e-mail you the Honeywell Owner's...

Jay...I will e-mail you the Honeywell Owner's Guide PDF file to you GMail address.

Programming starts on page 18...

Thanks.

Note: I do have the outdoor sensor attached to the IAQ.
01-28-09, 02:51 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Unhappy Not sure what happened...but everything was...

Not sure what happened...but everything was functioning and now my humidity won't go any higher than 34%...initialy it climbed to 40 plus. What would the proper settings be for the Honeywell IAQ /...
01-27-09, 01:20 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Thumbs up Beer 4U2 and Jay Beer 4U2...you two have been...

Beer 4U2 and Jay Beer 4U2...you two have been awsome with helping this "old retire" out with this install. Keep up the great work with helping others...

Rich
01-27-09, 12:51 PM
Replies: 18
Views: 17,427
Posted By RichNHS

FYI...if you need to close off your crawl space...

FYI...if you need to close off your crawl space vents manually...it is recommended that all crawl space vents be closed anytime the outdoor temp is 40 degrees of lower! The automatic closing vents...
01-27-09, 12:29 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Now we're cookin...wired up as you suggested and...

Now we're cookin...wired up as you suggested and we have steam flowing :thumbup::D

One more question: I run my variable speed furnace fan 24/7 and it automatically runs up the speed based on temp...
01-27-09, 09:40 AM
Replies: 33
Views: 3,763
Posted By RichNHS

Okay, then I should remove the "G" wire from the...

Okay, then I should remove the "G" wire from the IRQ pin that is now going to the TS "GT" pin and instead take the "G" wire coming from the Thermostat to the furnace "G" terminal and wirenut this...
01-27-09, 06:53 AM
Replies: 33
Views: 3,763
Posted By RichNHS

Connection and Dip setting

HUM wires from IAQ to pins on TS

R and C wires from IAQ to 24v pins on TS

SENSOR wires from IAQ to outdoor sensor

G from IAQ to GT on TS

GF from TS to G on furnace
01-26-09, 09:09 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Only LED light on is the POWER light...nothing...

Only LED light on is the POWER light...nothing from that point on...?:confused:

I have pressed the RESET and waited...no results

Also unplugged the unit and nothing happens other than the power...
01-26-09, 05:37 PM
Replies: 33
Views: 3,763
Posted By RichNHS

I completed hookup, per wiring instructions...

I completed hookup, per wiring instructions given, set TrueIAQ to maximum humidity 80%, powered up TrueSTEAm and noted that TrueSTEAm shows unit power on but NO WATER enters the unit ? Water shutoff...
01-23-09, 07:21 AM
Replies: 33
Views: 3,763
Posted By RichNHS

You are a busy man Jay... I logged on last night...

You are a busy man Jay... I logged on last night and noted that you got tied into "other" issues. :coffee:

Thanks for these final steps... we'll get back at you once completed :)

Have a GREAT...
01-23-09, 06:35 AM
Replies: 33
Views: 3,763
Posted By RichNHS

:gmorning: In waiting for your response, I have...

:gmorning: In waiting for your response, I have made some connections on my own (based on prior threads related to subject)... by connecting the following:

1- connected 2 HUM wires from TrueIAQ to...
01-21-09, 11:09 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Jay... I will be using the outside sensor and the...

Jay... I will be using the outside sensor and the IAQ since it provides my old eyes a better view of temp / humidity settings than the harder to see SignatureStat screen. Looking forward to your...
01-21-09, 01:11 PM
Replies: 33
Views: 3,763
Posted By RichNHS

Wiring hookup of Honeywell TrueSteam humidifier using TrueIAQ control

I'm stumped with making the proper wiring connections between the following units:

Lennox SignatureStat Model 81M27
Lennox Heat Pump XP19 (primary 2H/2C application)
Lennox gas G61MPV (Heating...
Showing results 1 to 21 of 21


 
Forum Jump