Search: Posts Made By: upstateNYMcLean
Showing results 1 to 9 of 9
Search took 0.01 seconds.
05-24-14, 08:33 PM
Replies: 74
Views: 22,244
Posted By upstateNYMcLean

I read your thread on Hayward Pool Heater startup...

I read your thread on Hayward Pool Heater startup issues. I recently bought a house with in-ground pool and Hayward H250FDP Propane Heater. The display panel lights go on and the unit fires up, but...
02-17-14, 08:12 PM
Replies: 38
Views: 5,867
Posted By upstateNYMcLean

I own a Gold Series Culligan and have no idea how to get it to work

So, Culligan service guy was here 3 wks ago and did a manual suction test...and felt he needed to add some small vial of cleaner or something...and purge the suction line (I think). He didn't stay...
02-28-07, 07:11 PM
Replies: 1
Views: 1,372
Posted By upstateNYMcLean

Question Exterior door with crack in raised panel

OK- Here's a good one for you carpenters and woodworkers out there. I have an exterior front door that has a crack running down the middle of one of the raised panels. The crack stays closed in the...
02-28-07, 07:02 PM
Replies: 6
Views: 6,371
Posted By upstateNYMcLean

Smile Feedback for all advice given

Dear all,
I wasn't comfortable with the jig saw idea, I didn't have a plumbing shop nearby, and I don't own a carbide laminate cutting knife. Sooo... I bit the bullet, used the mounting holes...
02-28-07, 06:53 PM
Replies: 2
Views: 950
Posted By upstateNYMcLean

Badoff- the first thing you need to determine is...

Badoff- the first thing you need to determine is whether you have a damp basement issue or an occasional or even frequent water infiltration issue. If your basement is just damp, with just moisture...
02-22-07, 07:55 AM
Replies: 6
Views: 6,371
Posted By upstateNYMcLean

Yeah. I was wondering if I could cut in on my...

Yeah. I was wondering if I could cut in on my table saw. It looks like between 1/32" and a 1/16" thick.

Anyone else have other suggestions?
Replies: 15
Views: 5,285
Posted By upstateNYMcLean

Post I was just wondering what the going price is now,...

I was just wondering what the going price is now, 3+ yrs later. I thought maybe between $400-500 USD, but I don't if that's a bit steep. I'd hate to see the thing go, with all accessories and...
02-21-07, 07:00 PM
Replies: 6
Views: 6,371
Posted By upstateNYMcLean

Cutting Brass Door plate

Help. I bought a 30" wide brass door plate and new to cut it down by 2" or so in length. What's the best thing to use to make a nice straight even cut, obviously keeping safety in mind?

Thanks.
Replies: 15
Views: 5,285
Posted By upstateNYMcLean

Deltashop Combination Tool

Brad, Rocketman, etc.- Hey, I'm coming into this discussion about 4 yrs late. My father owns a Deltashop Combination Tool (from Delta Homecraft Power Tools) similar to the one you described. It has...
Showing results 1 to 9 of 9


 
Forum Jump