Search: Posts Made By: dmm
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 11
Views: 3,501
Posted By dmm

What do you have for zones for 9-32? hardwired,...

What do you have for zones for 9-32? hardwired, wireless, or mixed?

You can't mix a wireless zone in to the same zone space as an expander (wired zone), you will end up with problems as you...
Replies: 1
Views: 1,345
Posted By dmm

Chamberlain Remote Q's

Hi

I'm looking for additional remotes for my GDO, but I've got a question about compatibility ...

In the manual it says for Keyless Entry, I should use the 940CD, but on the website they sell...
Replies: 9
Views: 1,375
Posted By dmm

see if you can get an older CFL. I had a...

see if you can get an older CFL. I had a Panasonic branded one that took like about 3 minuites to reach full brightness, starting it was very dim.
Replies: 26
Views: 16,760
Posted By dmm

how about looking at the bulb ... does it have...

how about looking at the bulb ... does it have any information like 12v 50w ? then find a transformer that can meet these specs?
Replies: 1
Views: 819
Posted By dmm

Keyed latchsets still exist?

Anyone know if they still make the handled portion with keys still (the part where you push with your thumb to open the latch)? Seems like most manufactures only use deadbolts as they key'ed portion.
Replies: 4
Views: 878
Posted By dmm

Where are the contacts installed on the door...

Where are the contacts installed on the door jamb?

If they are installed on the latch/lock side, when the contacts seperate, they seperate immediately as the door is opened.

If they are...
Replies: 4
Views: 1,169
Posted By dmm

Smile Auto scroll of open zones is available for V3.0...

Auto scroll of open zones is available for V3.0 and higher LCD5500 keypads.

Programming section [076] option 8 "ON" for Auto Scroll

V2.x and lower LCD5500 keypads did not support this option. ...
Replies: 2
Views: 1,317
Posted By dmm

If the power was cut, and the battery was not...

If the power was cut, and the battery was not functioning, check your trouble codes.

Press *2, if zone 1 is on, means battery is low still and if zone 8 is on, means system clock is not set...
Replies: 4
Views: 2,160
Posted By dmm

When you arm the system, and it starts instantly,...

When you arm the system, and it starts instantly, I assume this was under test conditions? basically you arm, counts down, ARM LED is ON, chime speeds up, then ready LED goes out, then you run and...
Replies: 6
Views: 10,276
Posted By dmm

Realistically, I've used both methods. ...

Realistically, I've used both methods. Programmming via keypad is faster. Only plus points of using the PC is backing up the programming, and if you use alpha-numeric keypads. Bad points it takes...
Showing results 1 to 10 of 10


 
Forum Jump