Search: Posts Made By: Jackruf
Showing results 1 to 16 of 16
Search took 0.01 seconds.
10-28-13, 01:04 PM
Replies: 1
Views: 709
Posted By Jackruf

Two lights controlled by one wall timer

Hi I have seen similar posts, but I am having trouble with my wiring and would appreciate some help. I have two side by side switches controlling separate outdoor lights. I replaced one with a GE...
06-08-13, 06:38 AM
Replies: 7
Views: 4,176
Posted By Jackruf

I eliminated the pigtail and connected the other...

I eliminated the pigtail and connected the other black to the power of the timer. The overhead light does not come on when the wall sconces are on
06-08-13, 05:35 AM
Replies: 7
Views: 4,176
Posted By Jackruf

Ray, I do have a bundle of white wires in the...

Ray, I do have a bundle of white wires in the back and one of the black wires obn the switch I want to add to the timer is pigtailed.

Thanks
06-07-13, 12:49 PM
Replies: 7
Views: 4,176
Posted By Jackruf

Ray, the switch, I wish to "piggyback" on the...

Ray, the switch, I wish to "piggyback" on the timer has two black wires. I will have to check this evening if there is a bundle of white wire in the box, but I do not recall seeing any.

Thanks
06-07-13, 11:55 AM
Replies: 7
Views: 4,176
Posted By Jackruf

Wiring Two Lights to One Timer

First, I would like to thank all the contributors to this forum for sharing your vast knowledge. I read the forum daily and am learning a tremendous amount.

I have an overhead light and two wall...
04-06-13, 11:51 AM
Replies: 1
Views: 649
Posted By Jackruf

2 grounds on one lug

Is it acceptable to secure two separate ground wires to one lug on the ground / neutral bus in my main panel?
03-09-13, 07:07 AM
Replies: 7
Views: 992
Posted By Jackruf

Interior wall is finished. A newbie question ---...

Interior wall is finished. A newbie question --- LB??

thanks for your advice
03-09-13, 06:51 AM
Replies: 7
Views: 992
Posted By Jackruf

Chandler, it would be close to impossible to run...

Chandler, it would be close to impossible to run a new continuous cable to the panel. If the only way to move the inlet box is to use a junction from the existing location, should I not move the...
03-09-13, 05:26 AM
Replies: 7
Views: 992
Posted By Jackruf

Outdoor conduit

I would like to reposition my generator inlet box approximately 15 feet further along the exterior wall. The cable feeding the inlet box is 10awg. I intend on replacing the existing inlet with a...
03-03-13, 08:31 AM
Replies: 7
Views: 5,075
Posted By Jackruf

That is exactly my intent. Thanks

That is exactly my intent. Thanks
03-03-13, 05:42 AM
Replies: 7
Views: 5,075
Posted By Jackruf

SoyBomb, in response to your reply--paragraph 1...

SoyBomb, in response to your reply--paragraph 1 -- you are correct. Paragraph 2 - I understand the entire system needs to and does support 30 amps. As to your third paragraph -- my question is -- can...
03-03-13, 05:01 AM
Replies: 7
Views: 5,075
Posted By Jackruf

Generator Plug - Newbie Question

Hi I am a long time reader of the forum and appreciate all the wisdom and experience shared by the community.

My existing portable generator has one 20amp L14-20 4 prong twist outlet which...
11-16-12, 02:09 PM
Replies: 11
Views: 15,129
Posted By Jackruf

Nashkat1, thank you for your help. Forgive my...

Nashkat1, thank you for your help. Forgive my ignorance, but aren't there two issues I need to be concerned with? 1) The fluctuation in voltage, which I understand the surge suppressor will correct...
11-16-12, 01:07 PM
Replies: 11
Views: 15,129
Posted By Jackruf

I do have a manual transfer switch and also have...

I do have a manual transfer switch and also have room to install a whole house suppressor. I understand the suppressor will eliminate the high voltage spikes, but what about issues surrounding the...
11-16-12, 05:05 AM
Replies: 11
Views: 15,129
Posted By Jackruf

Voltage Regulator for Generator

I am very concerned about the quality of power being produced by my older Generac 5500W generator. Does anyone know of a power filter that can be installed between the generator and the transfer...
11-04-12, 11:51 AM
Replies: 2
Views: 977
Posted By Jackruf

Generator Transfer Switch Wiring Question

Hi I am new to the forum and thank all in advance for sharing their knowledge -
I have a six circuit Emer-Gen manual transfer switch wired into my home. Several of the circuits on the transfer...
Showing results 1 to 16 of 16


 
Forum Jump