Search: Posts Made By: 2ndprimetime
Showing results 1 to 10 of 10
Search took 0.01 seconds.
12-07-10, 02:03 AM
Replies: 10
Views: 54,991
Posted By 2ndprimetime

Like Bud & Mike said "need more information on...

Like Bud & Mike said "need more information on location"
I would recommend not using foam insulation if the thermostat in the heat strip goes bad it could melt the foam
12-05-10, 02:11 AM
Replies: 12
Views: 3,230
Posted By 2ndprimetime

For it to meet International code you will need...

For it to meet International code you will need to have a air gap and a trap primer
12-05-10, 02:05 AM
Replies: 7
Views: 13,200
Posted By 2ndprimetime

I would use Uponor crosslinked pex it has a great...

I would use Uponor crosslinked pex it has a great warranty and easy to use you can buy it in rolls up to 500ft or in stick form.

Uponor - Plumbing Systems...
12-05-10, 01:57 AM
Replies: 11
Views: 1,814
Posted By 2ndprimetime

Make sure you test the pressure after the PRV. If...

Make sure you test the pressure after the PRV. If you have a check valve you need some type of thermal expansion devise. If the pressure tests at 65 psi or less you need to change the T&P they can go...
11-14-10, 04:13 AM
Replies: 6
Views: 4,432
Posted By 2ndprimetime

Kevin, Uponor makes a cross-linked pex that is...

Kevin,
Uponor makes a cross-linked pex that is legal in Cal. It's easy to install lead free and you can use a manifold and run 1/2 lines to each fixture with the bennifit of having a shut off for...
11-14-10, 03:58 AM
Replies: 8
Views: 1,394
Posted By 2ndprimetime

Greg, Back in the day we packed cast-iron...

Greg,
Back in the day we packed cast-iron joints with oakum and poured molten lead over the oakum along the top 1 in. of the bell-and-spigot and in a 2x4 wall the spigot would stick out.
You can...
11-14-10, 03:34 AM
Replies: 3
Views: 1,773
Posted By 2ndprimetime

Thanks Jay got it installed with the 8570 tstat...

Thanks Jay got it installed with the 8570 tstat with your help and workd great !!
11-14-10, 03:30 AM
Replies: 3
Views: 2,425
Posted By 2ndprimetime

Thanks Jay got it relocated and wired

Thanks Jay got it relocated and wired
11-11-10, 03:19 PM
Replies: 3
Views: 2,425
Posted By 2ndprimetime

Aprilaire 8570 wiring problem

I installed a Aprilaire 600 Hum. and pulled new wires for a Aprilaire 8570 the orig wires were only 4 strand My problem is there is no C on the T-stat this is what there is W1, W2, RH, R, RG, G, Y1,...
10-27-10, 10:35 AM
Replies: 3
Views: 1,773
Posted By 2ndprimetime

Aprilaire 600 install

I have a model 600 need to install it on a upflow install the problem is the unit will not fit on the supply side before it branches off can I install it on the return side and by pass it to the...
Showing results 1 to 10 of 10


 
Forum Jump