Search: Posts Made By: GeomanfromPA
Showing results 1 to 12 of 12
Search took 0.01 seconds.
08-02-12, 01:14 PM
Replies: 4
Views: 1,882
Posted By GeomanfromPA

The answer to your first question is no. ...

The answer to your first question is no. Regarding water temperature at other fixtures, I'll make a few measurements and post what I find. Thanks for your suggestion.
08-02-12, 01:11 PM
Replies: 4
Views: 1,882
Posted By GeomanfromPA

No. I haven't done any mechanical work yet. I...

No. I haven't done any mechanical work yet. I agree the timing of two going down is unusual.
08-02-12, 09:14 AM
Replies: 4
Views: 1,882
Posted By GeomanfromPA

No Hot Water at Single Handle Faucets

I have three separate showers in my home -- one has individual valves on the hot and cold feeds, and the other two are equipped with single lever faucets (Delta and Moen) . Recently, the maximum...
Replies: 2
Views: 1,031
Posted By GeomanfromPA

Fuel Oil Pressure

Recently, my plumber checked the fuel oil pressure on my Beckett AFG/Weil-McLain Gold Series 3 residential system and measured 100 psi. The specs call for 150 psi. Apparently, the fuel oil pressure...
Replies: 1
Views: 1,063
Posted By GeomanfromPA

Governor for B&S 120000 series engine

I recently inherited a Craftsman lawnmower with a 190 cc, 6.5 HP 120000 series B&S vertical shaft engine completely apart. I have reassembled most of the internals, but I have some questions...
Replies: 5
Views: 1,316
Posted By GeomanfromPA

Thanks to all the commenters for the excellent...

Thanks to all the commenters for the excellent advice. The problem was in fact a dead circulator, which I replaced yesterday. Heat distribution is now what it should be. Keep up the great work, it...
Replies: 5
Views: 1,316
Posted By GeomanfromPA

You are correct -- the boiler has a tankless...

You are correct -- the boiler has a tankless coil. I only use it to preheat water going into a 50-gallon electric HW heater. I think the circulator (Taco 007) is okay since I have warm - but not...
Replies: 5
Views: 1,316
Posted By GeomanfromPA

Boiler temperature vs, feed temperature

My question concerns a Weil-McLain WTGO-3 oil-fired boiler I use for home heating. The combination gauge on the boiler shows a normal operating temperature range of approximately 180-210 degrees. ...
Replies: 4
Views: 6,721
Posted By GeomanfromPA

UPGRADING TO hONEYWELL L7224U AQUASTAT

Thanks to NJ Trooper for the L6006C aquastat installation guidance. My unit heater is now up and running.

I plan to upgrade the triple aquastat on my Weil-McLain WTGO3 boiler from the original...
Replies: 7
Views: 22,521
Posted By GeomanfromPA

Thanks, NJ Trooper. I'm off to my garage to make...

Thanks, NJ Trooper. I'm off to my garage to make the connections. You and the other moderators of this forum Rock!
Replies: 7
Views: 22,521
Posted By GeomanfromPA

Thank you Grady and Trooper for your replies. ...

Thank you Grady and Trooper for your replies. This installation is a direct replacement for an inoperable aquastat, which was disconnected but, unfortunately, the connections were not labeled. The...
Replies: 7
Views: 22,521
Posted By GeomanfromPA

Wiring a Honeywell L6006C Reverse Action Aquastat

I'm looking for information on wiring a Honeywell L6006C aquastat for circulator fan control on a Sterling hydronic unit heater in my garage. The aquastat is mounted on the return line and has three...
Showing results 1 to 12 of 12


 
Forum Jump