Search: Posts Made By: davea
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 1
Views: 7,973
Posted By davea

Pole barn gutters

I have a pole barn with a steel roof it was cut about 3inches past the fascia will normal sized gutters work?
Replies: 1
Views: 1,389
Posted By davea

Prep Pole building for concrete slab

I need some advise.I have a 30x32 pole building that I,d like to geta concrete floor put in.There crush run in the building now.But I think I,ll need more.The question is ;there is a 6-12 inch gap...
Replies: 2
Views: 1,014
Posted By davea

info on prep for a large cement slab

I,m going to buy a 30x30 steel building I,m put it on a slab.I,m going to put a lift in it.I need a I need some advice and if some one knows of a good book with lots of pics and easy to follow...
Replies: 2
Views: 1,159
Posted By davea

Nobody knows?

Can,t believe nobody has welded cast alum. with a spoolgun.Has anybody read that it can or can,t be done?How about sheet alum.? or just a spoolgun in genaral.
Replies: 2
Views: 1,159
Posted By davea

Question Welding cast aluminumw/ spoolgun??

I need to be able to weld cast alum. such as ears on transmissions bellhousings,intake man,ect.I have a mig.I,ve used it without a spoolgun.(using a new liner/argon a bigger tip than the dia.of the...
Replies: 2
Views: 777
Posted By davea

alumumim hull repairs

This winter I,d like to take the deck off my Tracker and fix leaking rivots and small holes,and resecure ribs.Any I deals for a good epoxy or anhesave? How about weld sealer? Or the stuff they use...
07-04-06, 10:47 AM
Replies: 3
Views: 840
Posted By davea

re 3rd dampner

Would I leave that dump open if I did away with the zone.Its a small room down stairs,and 3 bed rooms upstairs.Are ther any sites w/ diagrams on systems or articals on balancing?
07-02-06, 08:44 AM
Replies: 3
Views: 840
Posted By davea

Balancing What is the 3rd dampnter for?

I have a zone control that runs upstairs and downstairs in a edition.I,m going to try manually balance since the motors don,t seem to be working I have 3 dampner.two I,m pretty sure I figured out...
06-30-06, 12:11 PM
Replies: 2
Views: 691
Posted By davea

ya as far as the dampners I think I can play...

ya as far as the dampners I think I can play with the balancing.I,m not sure how to by pass the controls. Somone said I could use the T stat,s I have just by pass the the main controller.I,ve...
06-29-06, 07:06 PM
Replies: 2
Views: 691
Posted By davea

Ripping out a zone control

I have a Carrier heat pump w/a Parker zone control.Its been acting up.No body whats to work on it.They want to rip it out .Can I rip it out.Ive worked on it.I can do alot of electrical diag.Would...
Showing results 1 to 10 of 10


 
Forum Jump