Search: Posts Made By: Matt_o76
Showing results 1 to 5 of 5
Search took 0.01 seconds.
01-21-17, 02:52 PM
Replies: 7
Views: 1,247
Posted By Matt_o76

The ground wire that came with the new control...

The ground wire that came with the new control board wasn't installed. This is why it wouldn't fire and was getting 6 flashes.
01-19-17, 08:22 PM
Replies: 7
Views: 1,247
Posted By Matt_o76

I replaced the control board because I couldn't...

I replaced the control board because I couldn't get it to fully cylce and now its cycling everytime for me, just not firing up all the time.

It fires on the low side. Do you think it has to do...
01-19-17, 08:09 PM
Replies: 7
Views: 1,247
Posted By Matt_o76

I got got about 16 v when it fired and now its...

I got got about 16 v when it fired and now its running and I have a 1.7 for my low fire gas valve output.
01-17-17, 09:18 PM
Replies: 7
Views: 1,247
Posted By Matt_o76

I had about 6.5 on the input. I couldn't get it...

I had about 6.5 on the input. I couldn't get it to fire to get an output reading. I will get back with you for a voltage reading. I feel the valve actuating when the ignitor fires. Then the unit...
01-17-17, 05:56 PM
Replies: 7
Views: 1,247
Posted By Matt_o76

Electronic ignitor comes on but burners only come on every once in a while.

This is a Ruud two stage natural gas furnace. I can feel the
Gas valve try and open but it doesn't. Any help would be appreciated.
Showing results 1 to 5 of 5


 
Forum Jump