Search: Posts Made By: fanman
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Replies: 3
Views: 5,767
Posted By fanman

Leaving lights on all day to stop mould

How much difference does leaving the lights on make?
Replies: 1
Views: 1,755
Posted By fanman

How to get grease off my hills hoist clothesline

On the inner ring of my clothesline they are covered in grease for some reason. How should i clean it to remove it all?
Replies: 3
Views: 962
Posted By fanman

Cleaning up a smashed energy saving lightbulb?

I heard there is toxic mercury in them. How should I clean it up?
08-13-08, 01:46 AM
Replies: 3
Views: 887
Posted By fanman

Window airconditioner powerful enough to increase temperature from 32 to 68

The temperature varies widely where I live.

How big or powerful an airconditioner would I need that would be able to keep my room at up to 68 when the outside is 32 degrees?
08-06-08, 05:36 AM
Replies: 2
Views: 1,072
Posted By fanman

Sparks flying when i cut log on ground

I was cutting up a log on the ground. Sparks started to fly. Would this be from the fast moving teeth hitting the saw dust on the ground or would it be something else?
08-05-08, 04:08 PM
Replies: 2
Views: 853
Posted By fanman

Trees: cutting off the smaller leafy branches and leaving the thick branch

This tree overhangs from my neighbours I cut off large amounts. I left up some bare think branches. Like that blue line one is like a cross bar of a football post I thought I could lean my ladder...
07-31-08, 10:34 PM
Replies: 1
Views: 853
Posted By fanman

Air conditioner stops and says 10 degrees

Im in Australia. Our measurements are celsius.

So our normal temperature we put it on is 20 degrees. Which is 70. Sometimes my aircon stops and it starts flashing 10 degrees on my screen(50 F).
...
Replies: 5
Views: 1,912
Posted By fanman

I cut through a 1/2 inch thick piece of metal...

I cut through a 1/2 inch thick piece of metal pretty easily.

The biggest and smallest diameters of the things im cutting are 100mm and 200mm.

I used a hand saw with small teeth. Will this cut...
Replies: 5
Views: 1,912
Posted By fanman

what do i need to cut a half inch diameter piece of round metal

Is there any hand saws i could use or a angle grinder best?
Replies: 2
Views: 1,351
Posted By fanman

What is the best thing to clean windows and the metal and wooden edges?

Im concerned about getting the wood and paintwork wet when i clean the edges of windows. Im worried about water running down into the wood,stucko, painted walls,etc. when i clean the glass.

This...
Replies: 5
Views: 1,341
Posted By fanman

Is there a minimum temperature you should wait...

Is there a minimum temperature you should wait till you open your windows in the morning? Like can dew get inside if it is too cold?
Replies: 5
Views: 1,341
Posted By fanman

Do you think fans are best put in obscure places...

Do you think fans are best put in obscure places where there is not much air flow as opposed to putting them near windows and doors like exhaust fans.

Like I imagine the ares of the room near...
Replies: 5
Views: 1,341
Posted By fanman

Can you over use your fans to prevent mildew?

I got pedestal fans all around my room blowing against the walls can this damage them at all?
Showing results 1 to 14 of 14


 
Forum Jump