Search: Posts Made By: fg12351
Showing results 1 to 25 of 29
Search took 0.01 seconds.
11-13-12, 11:23 AM
Replies: 7
Views: 8,301
Posted By fg12351

Schedule 40 white PVC I believe. Backwater...

Schedule 40 white PVC I believe.

Backwater valve would go where?

Yeah I was looking for a saddle wye for a 3 inch but no luck.
11-13-12, 10:22 AM
Replies: 7
Views: 8,301
Posted By fg12351

Lawrosa, Thanks for the info: Can you...

Lawrosa,

Thanks for the info:

Can you clarify your statement below?

"Remeber a backwater valve. The Y needs to be put on a 45 where you tie in. Where that is is important also."

Are you...
11-13-12, 06:41 AM
Replies: 7
Views: 8,301
Posted By fg12351

Pulpo, From everything I have read online I...

Pulpo,

From everything I have read online I need to use a drain pump attached to a utility sink to pump the washer drain water up vertically the 7' to 8' to the horizontal drain line running...
11-12-12, 07:11 PM
Replies: 7
Views: 8,301
Posted By fg12351

New basement laundry drain and venting question

Hey all,

I am working on moving my washer and dryer into the basement.

I will be working on running water lines and have the electrical done.

I plan on draining the washer into a utility...
Replies: 4
Views: 32,659
Posted By fg12351

No, no drain down there, floor drains only. The...

No, no drain down there, floor drains only. The laundry room where the washer and dryer currently reside is on the 1st floor above the basement location where I want to move them. Just heard back...
Replies: 4
Views: 32,659
Posted By fg12351

Clothes Washer drain into existing sump pump and pit

Looking at moving clothes washer into basement and wondered if draining into existing sump pump pit is a good idea, it has an output pipe that I am not sure where it goes, it looks like it does not T...
03-11-12, 07:06 AM
Replies: 4
Views: 10,046
Posted By fg12351

Any concerns with the subfloor being OSB and not...

Any concerns with the subfloor being OSB and not plywood? I read somewhere where it it's not built for the load of tile.
03-10-12, 06:43 AM
Replies: 4
Views: 10,046
Posted By fg12351

Question Ceramic Tile subfloor requirements

Hey all,

I have a question on subfloor requirements for putting down ceramic tile. We are remodeling our laundry room and I have ripped out the existing laminate floor and plywood layer down to...
02-26-12, 05:14 PM
Replies: 4
Views: 3,544
Posted By fg12351

The joists are 16" center to center, actually...

The joists are 16" center to center, actually some are 15" and some are 17" and some are doubled up??? but 16" is the average. The joists are 2 x 10's. The subfloor\underlayment is 23/32" thick.
...
02-26-12, 12:46 PM
Replies: 4
Views: 3,544
Posted By fg12351

Question Repairing\Replacing moldy subfloor

DIY Newb here,

I found mold in the subfloor of my laundry room under the dryer vent area. I can see black mold on the underside of the OSB in the basement.

Any idea on best way to fix this?
...
02-26-12, 12:38 PM
Replies: 2
Views: 1,454
Posted By fg12351

Drywall Repair Advice

Hey all,

I have a question on drywall repair.

I pulled up the baseboard in our laundry room behind the washer and dryer to prep to paint the room and foundblack mold on the drywall behind the...
06-02-11, 07:57 AM
Replies: 5
Views: 1,464
Posted By fg12351

Hey guys, here is an update: I put in a 300...

Hey guys, here is an update:

I put in a 300 level air filter and took out the 1500 level filter. I thought I could feel increased airflow out of the vents throughout the house (or maybe it was...
06-01-11, 09:37 AM
Replies: 5
Views: 1,464
Posted By fg12351

FYI, the basement is mainly finished except for a...

FYI, the basement is mainly finished except for a room where the HVAC unit, sump pump, water heater, etc. are located.
06-01-11, 09:32 AM
Replies: 5
Views: 1,464
Posted By fg12351

Question Time for a new AC unit? What else can we check?

Hi all,

This is a long one...

My wife and I recently purchased an 18 year old two story home with a basement. Each floor including the basement is approximately 1200 to 1300 square feet. We...
Replies: 11
Views: 830
Posted By fg12351

Hey guys here is an update: After talking to...

Hey guys here is an update:

After talking to my neighbor we looked at his shower fixtures and he actually has the original knob cover that says "Mixet" on it. Mixet went out of business years ago...
Replies: 11
Views: 830
Posted By fg12351

Lawrosa, By just replace the handle you are...

Lawrosa,

By just replace the handle you are referring to the acrylic knob only correct?

That's what I have been looking for but not having any luck. They have replacement acrylic knobs
but...
Replies: 11
Views: 830
Posted By fg12351

The inside plastic slot of the knob where it...

The inside plastic slot of the knob where it grips the cartridge is broken and it will no longer stay on. Plus the screw is missing and it's cracked and pretty funky throughout and I want to replace...
Replies: 11
Views: 830
Posted By fg12351

Thanks, let me know if these work on photobucket....

Thanks, let me know if these work on photobucket.

http://i1096.photobucket.com/albums/g338/fg12351/DeltaFaucet.jpg
http://i1096.photobucket.com/albums/g338/fg12351/DeltaFaucet2.jpg
Replies: 11
Views: 830
Posted By fg12351

http://i52.tiny pic.com/2lxa5vl.jpg ...

http://i52.tiny pic.com/2lxa5vl.jpg
http://i52.tiny pic/547id.jpg
Replies: 11
Views: 830
Posted By fg12351

http://i52.************/547id.jpg ...

http://i52.************/547id.jpg
http://i52.************/2lxa5vl.jpg
Replies: 11
Views: 830
Posted By fg12351

Question Can I put in a new cartridge and trim pieces without replacing the valve?

Hi all,

We have an old Delta tub faucet in our rental property that has a lever for controlling the hot\cold temperature that sits behind an acrylic knob for turning the water on and off (see pic)...
05-16-11, 09:45 AM
Replies: 10
Views: 9,340
Posted By fg12351

Thanks for the input guys, It looks like I will...

Thanks for the input guys, It looks like I will be cutting into the drywall.
05-16-11, 08:38 AM
Replies: 10
Views: 9,340
Posted By fg12351

Michael, The interior of the basement is...

Michael,

The interior of the basement is finished so I cannot locate another valve to turn on and off the water at that hose bib, I only used the bib on the exterior of the home to turn the water...
05-15-11, 06:52 PM
Replies: 10
Views: 9,340
Posted By fg12351

We are getting new siding put on the house in the...

We are getting new siding put on the house in the next few weeks, the spigot comes out of the concrete a few inches below the siding, with the siding removed with this give me any access to do...
Showing results 1 to 25 of 29
 


 
Forum Jump