Search: Posts Made By: brandonmckinney
Showing results 1 to 25 of 29
Search took 0.01 seconds.
11-28-16, 09:50 PM
Replies: 6
Views: 1,619
Posted By brandonmckinney

Here is are some fun facts: My Heat Pump is...

Here is are some fun facts:

My Heat Pump is a Goodman GSZ13 with a SEER of 13 and HSPF of 8 (Bottom of the line Heat Pump, not my doing)
The Cost of Electricity is: $0.0908/KWH
The Cost of...
11-28-16, 09:28 PM
Replies: 6
Views: 1,619
Posted By brandonmckinney

Well I decided to hook my thermostat up to my...

Well I decided to hook my thermostat up to my fireplace so that my Heat Pump and Fireplace can work in conjunction with one another especially when it doesn't get above 40 degrees for weeks on end. ...
11-25-16, 10:00 AM
Replies: 1
Views: 561
Posted By brandonmckinney

Where to find VAC Input to VDC Output Relay?

I am looking for a VAC to VDC Relay. Roughly 3-32VAC Input 2-24VCD Output. I am running a Gas Fireplace off my thermostat. The thermostat is putting out about 17VAC to trigger the auxiliary heat in...
11-18-16, 07:44 AM
Replies: 6
Views: 1,619
Posted By brandonmckinney

I would like to set this up so that my fireplace...

I would like to set this up so that my fireplace and my heat pump stop battling each other. It would also be nice for the fireplace to help supplement the heat pump when it gets cold outside below...
11-17-16, 07:48 PM
Replies: 6
Views: 1,619
Posted By brandonmckinney

Thermostat to control Heatpump & Fireplace

I have a Heat Pump with built in electric heat as a auxiliary/backup/emergency heat. I also have a natural gas fireplace. I would like one thermostat that I can use to control both. This is what I...
Replies: 15
Views: 64,092
Posted By brandonmckinney

Thanks Mike, I did this and it is exactly as you...

Thanks Mike, I did this and it is exactly as you described. This is my problem. It seems like my flame height could still be a little higher, at least compared to my brother-in-laws fireplace who...
Replies: 15
Views: 64,092
Posted By brandonmckinney

Here is a diagram fireplace system configuration...

Here is a diagram fireplace system configuration that I have as well as a close up of the valve body with stepping motor.

60970
60972

Here is a link to the manual...
Replies: 15
Views: 64,092
Posted By brandonmckinney

I believe at least part of my problem is that my...

I believe at least part of my problem is that my stepping motor is adjusting the flame height adjustment screw too far out. I can take the stepping motor off the valve and adjust the screw setting...
Replies: 15
Views: 64,092
Posted By brandonmckinney

It seemed to burn fine/better before, in other...

It seemed to burn fine/better before, in other words this hasn't always been a problem.
Replies: 15
Views: 64,092
Posted By brandonmckinney

Gas Fireplace Low Flame

I have a direct vent gas fireplace insert. It is a Monessen Hearth BDV400 to be exact. My issue is that it has a low flame height. The tallest flames I can get are about 5 inches mostly blue with an...
05-07-12, 08:52 PM
Replies: 14
Views: 6,937
Posted By brandonmckinney

I finally got all my programming and outdoor...

I finally got all my programming and outdoor temperature sensor figured out and installed. I started this whole process in February when my energy bill was getting a bit steep for my checkbook. Just...
05-07-12, 07:32 PM
Replies: 15
Views: 2,122
Posted By brandonmckinney

I didn't but I will. I don't remember exactly...

I didn't but I will. I don't remember exactly what setting it was.
05-07-12, 11:57 AM
Replies: 15
Views: 2,122
Posted By brandonmckinney

I have adjusted the wiring to what I believe it...

I have adjusted the wiring to what I believe it should be. I have taken some before and after pictures and will post them below.

Thermostat Before Adjustment...
04-25-12, 09:59 PM
Replies: 15
Views: 2,122
Posted By brandonmckinney

I am assuming that one of the wires is going to...

I am assuming that one of the wires is going to the 30amp electric strip heat and the other is going to the 50amp strip heat. I will try and confirm.

I am assuming that they should not be...
04-25-12, 04:39 PM
Replies: 15
Views: 2,122
Posted By brandonmckinney

http://i1058.photobucket.com/albums/t410/mckinneyb...

http://i1058.photobucket.com/albums/t410/mckinneybrandon/IMG_0429.jpg
04-25-12, 02:23 PM
Replies: 15
Views: 2,122
Posted By brandonmckinney

There are two wires (1 black, 1 white) connected...

There are two wires (1 black, 1 white) connected to the aux connection and nothing connected to the E connection.

I have a picture but can't upload it from my iPhone.

Thanks,

Brandon
04-25-12, 07:35 AM
Replies: 15
Views: 2,122
Posted By brandonmckinney

Yes. I believe there is a 30amp and a 50amp...

Yes. I believe there is a 30amp and a 50amp electric strip heat backup. This system is use in a 3400sq ft house.

There is not an outdoor sensor on the thermostat.

Thanks,

Brandon
04-24-12, 09:04 PM
Replies: 15
Views: 2,122
Posted By brandonmckinney

Thanks Houston and Jay. Jay I know you have...

Thanks Houston and Jay.

Jay I know you have helped me before with the advanced programming settings on the Honeywell Vision Pro. My father is using the same thermostat. Should I program it as I...
04-23-12, 11:23 AM
Replies: 15
Views: 2,122
Posted By brandonmckinney

Climate Master Heat Pump with Honeywell Vision Pro

My father has a Climate Master ground loop heat pump. It is model number VT048GSSSRTDDSH. He has a Honeywell Vision Pro thermostat. I am looking for some suggestions on programming of the thermostat...
04-10-12, 07:16 PM
Replies: 7
Views: 2,002
Posted By brandonmckinney

I will change these settings next time I am over...

I will change these settings next time I am over there. Is this a system that is best to set and forget?
04-09-12, 06:38 PM
Replies: 7
Views: 2,002
Posted By brandonmckinney

The model number is 4ycc3036a1075aa.

The model number is 4ycc3036a1075aa.
04-08-12, 09:02 PM
Replies: 14
Views: 6,937
Posted By brandonmckinney

Done. Any suggestions on a new air filter? We...

Done. Any suggestions on a new air filter? We have a lot of dust in our valley and a lot of allergens as well. You have any suggestions or does it even matter or help?
04-08-12, 08:57 PM
Replies: 7
Views: 2,002
Posted By brandonmckinney

Trane Packaged Unit and Honeywell Vision Pro

I am looking for some suggestions on programming for a Trane Packaged Unit running Gas/Electric I believe. I am not real familiar with this kind of heating/cooling system this is. The thermostat is a...
04-08-12, 08:52 AM
Replies: 14
Views: 6,937
Posted By brandonmckinney

I changed 170 back to 7. 270 is Emergency...

I changed 170 back to 7.

270 is Emergency heat cycle rate, setting 9 is Electric auxiliary heat or electric furnaces.

Air filter is a Glasfloss Industries Class 2 166N...? Not sure what any of...
04-07-12, 06:21 PM
Replies: 14
Views: 6,937
Posted By brandonmckinney

UPDATED PROGRAMMING 160 = 0 170 = 12 ...

UPDATED PROGRAMMING

160 = 0
170 = 12
190 = 0
200 = 0
220 = 2
230 = 3
260 = 3
270 = 9
Showing results 1 to 25 of 29
 


 
Forum Jump