Search: Posts Made By: rbro03
Showing results 1 to 25 of 58
Search took 0.01 seconds.
01-14-21, 03:33 AM
Replies: 6
Views: 426
Posted By rbro03

Hey Pjmax, sorry to be a pain. Do you think I...

Hey Pjmax, sorry to be a pain. Do you think I should just add another thermostat ? I really think the prestige can do this though...
01-06-21, 09:44 AM
Replies: 6
Views: 426
Posted By rbro03

Hey Pjmax, were you able to come up with a a...

Hey Pjmax, were you able to come up with a a configuration? Any help is appreciated. Thank you
12-26-20, 05:33 AM
Replies: 6
Views: 426
Posted By rbro03

Any luck on the correct set up ?

Any luck on the correct set up ?
12-21-20, 07:53 AM
Replies: 6
Views: 426
Posted By rbro03

Prestige IAQ Honeywell YTHX9421R5101WW

Need help configuring my Prestige stat. (Honeywell YTHX9421R5101WW)
I currently have it configured to operate the heat pump and hot water coil with fan. I have it using the heat pump until the temp...
12-16-17, 04:46 AM
Replies: 5
Views: 1,643
Posted By rbro03

Ha ha!!!!! Thanks a lot for the input..you guys...

Ha ha!!!!! Thanks a lot for the input..you guys are great....
12-15-17, 09:50 AM
Replies: 5
Views: 1,643
Posted By rbro03

Houston, How does this look ?

Houston, How does this look ?
12-13-17, 02:34 AM
Replies: 5
Views: 1,643
Posted By rbro03

Fan Wirting

no wiring diagram. yes, the t stat is wired. and I do have access to the connections. I have it wired with an aquastat and a zone valve now and it works fine in heat mode and fan set to auto. would...
12-12-17, 07:27 AM
Replies: 5
Views: 1,643
Posted By rbro03

Cool fan wiring for a hydronic unit heater

need help please. I have a hydronic unit heater in my garage (110v. fan motor). I have a SENSI wifi t-stat, I have the fan wired thru an aquastat and it works fine. I would like to wire it so I can...
06-13-16, 02:56 AM
Replies: 86
Views: 12,496
Posted By rbro03

Thanks Houston, yes they match, I am thinking my...

Thanks Houston, yes they match, I am thinking my whole problem is not enough return air. I have a central return 14 inch with a 14 x 25 grille. and a 6 inch with a 10x 10 grille. I am going to add...
06-09-16, 02:09 PM
Replies: 86
Views: 12,496
Posted By rbro03

Houston, I don't know if I attached the jpeg file...

Houston, I don't know if I attached the jpeg file correctly. not very computer savy.
06-07-16, 03:05 PM
Replies: 86
Views: 12,496
Posted By rbro03

Did you get the pic. of the dip switches ?

Did you get the pic. of the dip switches ?
06-04-16, 02:35 PM
Replies: 86
Views: 12,496
Posted By rbro03

The delta is at 13 degrees 57 supply and 70 at...

The delta is at 13 degrees 57 supply and 70 at the return . The return is located in the hallway, no supply near. the stat also reads 70. there is no furnace I have a hot water coil in the duct...
06-04-16, 12:39 PM
Replies: 86
Views: 12,496
Posted By rbro03

Hey Houston, I did exactly as you said. I ran a...

Hey Houston, I did exactly as you said. I ran a jumper from R to U2 and from other U2 terminal to dehumid.on blower, I reconfigured the tstat on dehumid to run at low. I also configured the dip...
06-02-16, 04:26 PM
Replies: 86
Views: 12,496
Posted By rbro03

I just checked delta T. OUTSIDE TEMP 71 HUMIDITY...

I just checked delta T. OUTSIDE TEMP 71 HUMIDITY 57 PERCENT

STAGE1 DELTA 17-DISCHARGE 55 RETURN 72

STAGE2 DELTA 16-DISCHARGE 55 RETURN 71

I ran them for 10 minutes each. indoor temp was...
06-02-16, 03:32 PM
Replies: 86
Views: 12,496
Posted By rbro03

I will check when I get home, still at work ...

I will check when I get home, still at work Thanks
06-02-16, 02:49 PM
Replies: 86
Views: 12,496
Posted By rbro03

I just found a pic of the connections in my...

I just found a pic of the connections in my phone, the condenser yellow is Y2 and Y1 is a purple wire
06-02-16, 02:44 PM
Replies: 86
Views: 12,496
Posted By rbro03

I will check the connections at the condenser as...

I will check the connections at the condenser as soon as possible, Do you think I have them reversed?
06-02-16, 10:41 AM
Replies: 86
Views: 12,496
Posted By rbro03

Ok. I will try this, Do I configure the U2...

Ok. I will try this, Do I configure the U2 terminals normally open or closed ?
06-02-16, 07:40 AM
Replies: 86
Views: 12,496
Posted By rbro03

Houston, Yes the stages and blower are operating...

Houston, Yes the stages and blower are operating correctly, I am sure if I somehow utilize the stage two longer, the humidity will drastically reduce. (I ran stage two last nite in a test mode for...
06-01-16, 02:34 PM
Replies: 86
Views: 12,496
Posted By rbro03

prestige model # Honeywell YTHX9421R5101WW

prestige model # Honeywell YTHX9421R5101WW
06-01-16, 02:29 PM
Replies: 86
Views: 12,496
Posted By rbro03

Sorry Houston, I am referring to the Prestige set...

Sorry Houston, I am referring to the Prestige set up. where do I change the comfort setting for stage two, is that in the setup menu ?
06-01-16, 01:25 PM
Replies: 86
Views: 12,496
Posted By rbro03

Houston, I do have another concern maybe you can...

Houston, I do have another concern maybe you can help me with. This unit does not seem to be dehumidifying as my old unit did. Is it because of it running longer periods on stage one cooling?...
06-01-16, 05:28 AM
Replies: 86
Views: 12,496
Posted By rbro03

a/c pressure question

Hi Houston, just a question regarding suction pressure on my goodman 3ton 18 seer condensing unit. when the compressor is running at stage one cooling I am getting a suction pressure of around...
01-29-16, 07:20 AM
Replies: 86
Views: 12,496
Posted By rbro03

Prestige 2.0

Hey Houston, Just a little confusion on my end. I am going to hard wire to boiler, can I connect to the Gateway and use my phone App. without the EIM? and if I do need an EIM, can I use the existing...
01-27-16, 07:30 AM
Replies: 86
Views: 12,496
Posted By rbro03

Prestige 2.0

Thanks Houston, Do I need to hardwire the TH8110R to the EIM or can I do it wireless ? Also, do you know if I can operate both units on the same app. from my phone, or do I need to download a second...
Showing results 1 to 25 of 58
 


 
Forum Jump