Search: Posts Made By: Siegfried1
Showing results 1 to 16 of 16
Search took 0.01 seconds.
Replies: 26
Views: 3,609
Posted By Siegfried1

Was able to start and run engine 2X on starting...

Was able to start and run engine 2X on starting fluid after loading the engine head with WD40. It would not sustain on its own. I was not able to start it again even after waiting 20 minutes. Fuel...
Replies: 26
Views: 3,609
Posted By Siegfried1

Took the diesel feed tube connection off the...

Took the diesel feed tube connection off the engine block. The piston, I think injector pump piston), does go up and down. No fuel however gets beyond this point, to the injector.
Replies: 26
Views: 3,609
Posted By Siegfried1

went through the manual, primed through port at...

went through the manual, primed through port at top of cylinder head. Reviewed all of manual instructions. I am still not getting fuel through the injector pump up to the injector. Also, it does...
Replies: 26
Views: 3,609
Posted By Siegfried1

Fuel gets top the pump. Fuel does not get...

Fuel gets top the pump. Fuel does not get through the pump. It therefore does not get up the metal tube to the injector. The pump piston does go up and down. A valve inside the pump that is stuck?
Replies: 26
Views: 3,609
Posted By Siegfried1

Cleaned the injector. Took all connections apart...

Cleaned the injector. Took all connections apart again and cleaned. Attempted restart, this time priming with WD40. No start. I will stop attempting until I have another brainstorm to try. ...
Replies: 26
Views: 3,609
Posted By Siegfried1

No fuel flow from injector

The injector does not appear to operate. It is a piston from inside the crank shaft. The piston goes up and down, but fuel does not flow. There is fuel flowing to the injector, by gravity.
...
Replies: 26
Views: 3,609
Posted By Siegfried1

Still won't start

Hi,
Removed fuel line to injector. Fuel flows. Removed line from injector. No fuel when turning engine over.

Removed injector head, injector piston moves when turning over. Added fuel to top...
Replies: 26
Views: 3,609
Posted By Siegfried1

Cannot locate owner's manual

This is a one cylinder engine. I do not have an owner's manual.
Replies: 26
Views: 3,609
Posted By Siegfried1

Diesel pump won't start

Purchase new diesel pump 5 years ago. Never fueled it never ran it. Filled it with diesel and oil and attempted to start it. It was extremely hard to pull the starter rope when the unloader valve...
Replies: 14
Views: 1,236
Posted By Siegfried1

Cleaned Carburator; Equipment operates...

Cleaned Carburator; Equipment operates satisfactorily; thanks to everyone for their help. I would close this thread, but I don't know how.

Thanks again
Replies: 14
Views: 1,236
Posted By Siegfried1

Valve stems shortened, .005 and .010. Engine...

Valve stems shortened, .005 and .010. Engine started, ran short time. Died when opening choke. Appears to have a fuel flow problem. Compression only 90 psi.
Replies: 14
Views: 1,236
Posted By Siegfried1

Thanks. How much clearance should I have after...

Thanks. How much clearance should I have after shaving the valve stem?
Replies: 14
Views: 1,236
Posted By Siegfried1

Thanks for your input. I have not taken the...

Thanks for your input. I have not taken the crank case apart and have therefore not accessed the rocker arms, if it has them. Should I completely dissasemble the engine and drive train to access...
Replies: 14
Views: 1,236
Posted By Siegfried1

I have removed the carburator assembly. exhaust...

I have removed the carburator assembly. exhaust and the head. I have opened the access to the valve springs. There is no seperation between the valves and the drive rods at full compression. The...
Replies: 14
Views: 1,236
Posted By Siegfried1

Checked compression - 60 psi. Where do I go from...

Checked compression - 60 psi. Where do I go from here? Rings, valves, etc. I dont'know how, but can learn. Any easy fixes?
Replies: 14
Views: 1,236
Posted By Siegfried1

Briggs and Stratton won't start

Purchased used high weed mower last year with a B&S model 196422, type 1162-E1 engine. Used one time last year. It ran rough. This year it will not start. Engine turns over. Good spark at spark...
Showing results 1 to 16 of 16


 
Forum Jump