Search: Posts Made By: daguercuzmar
Showing results 1 to 25 of 29
Search took 0.01 seconds.
02-26-21, 09:05 AM
Replies: 8
Views: 382
Posted By daguercuzmar

I am unable to cancel the order.Since there are...

I am unable to cancel the order.Since there are no exterior stops and the interior stops are actually sheetrock, should I replace the windows from the outside? If so, remove vinyl siding, remove J...
02-26-21, 04:51 AM
Replies: 8
Views: 382
Posted By daguercuzmar

I just read your response this morning and made...

I just read your response this morning and made the mistake you mentioned on your post. Bought replacement windows with rough opening 37"x56" with no nail fins, and they adjusted the measurements to...
02-25-21, 02:30 PM
Replies: 8
Views: 382
Posted By daguercuzmar

There is sheetrock all around the window, so I...

There is sheetrock all around the window, so I made some cut at the corners, and the frame may be embedded. See pictures...
02-25-21, 08:55 AM
Replies: 8
Views: 382
Posted By daguercuzmar

Windows replacement

We currently have aluminum windows that are very old, and I want to replace them with vinyl windows. The house was built in 1987 and has vinyl siding. The measurements from the inside are 37"x56"...
Replies: 14
Views: 1,179
Posted By daguercuzmar

Thank you very much for your feedback. I will...

Thank you very much for your feedback. I will lower the house drain pipe according to code.
Replies: 14
Views: 1,179
Posted By daguercuzmar

That is what I thought too. However, I saw a...

That is what I thought too. However, I saw a video in the web where the plumber inserted a tail to the P-trap as below. So, is this inaccurate?
...
Replies: 14
Views: 1,179
Posted By daguercuzmar

Based on post#6, could I add a tail-piece coming...

Based on post#6, could I add a tail-piece coming off the left bowl and lower the P-trap? Would that be against code? Lowering the house drain pipe is my last choice as the drain pipe may be...
Replies: 14
Views: 1,179
Posted By daguercuzmar

I replaced it straight out of the disposal;...

I replaced it straight out of the disposal; however, it is not level. See picture...
Replies: 14
Views: 1,179
Posted By daguercuzmar

Garbage disposal discharge tube lower than drain pipe

I am replacing my kitchen countertop, sink, and garbage disposal. The new kitchen sink is deeper than the old one, and with a new garbage disposal, the garbage disposal discharge tube is now lower...
Replies: 7
Views: 1,101
Posted By daguercuzmar

I talked to the vendor company, and they stated...

I talked to the vendor company, and they stated that the air filter box for 150cc engines don't have an inlet that can receive the tubing from the crank case breather anymore. What is the solution?...
Replies: 7
Views: 1,101
Posted By daguercuzmar

Thank you for your response. I am assuming the...

Thank you for your response. I am assuming the vendor sent me the wrong part? or do new small engines not have a crank case breather?
Replies: 7
Views: 1,101
Posted By daguercuzmar

Go Kart 150 GKA-2 series off road issues

I have a 150GKA-2 Series off-road go-kart. Engine type is a single cylinder, four strokes wind cooling (9KNX.150GMA). We havenít used this go-kart in 5 years, and we are trying to fix it before we...
Replies: 15
Views: 656
Posted By daguercuzmar

Guard is a synonym of rail

Guard is a synonym of rail
Replies: 15
Views: 656
Posted By daguercuzmar

Ended up rebuilding the entire desk ( non-ledger...

Ended up rebuilding the entire desk ( non-ledger deck) using DCA6 (https://www.awc.org/pdf/codes-standards/publications/dca/AWC-DCA62015-DeckGuide-1804.pdf), (2015 IRC code compliant guide). I am...
Replies: 15
Views: 656
Posted By daguercuzmar

XSleeper, the concrete blocks are not all filled....

XSleeper, the concrete blocks are not all filled. So , I guess I have to build a non-ledger deck? How close to the house should I dig another set of 6x6 posts? I have been reading some materials and...
Replies: 15
Views: 656
Posted By daguercuzmar

Should I use Sleeve anchors or wedge anchors?...

Should I use Sleeve anchors or wedge anchors? Again, I am attaching a ledger board 2 x 8 x 12 to a Block filled concrete. Which one is better?
Replies: 15
Views: 656
Posted By daguercuzmar

Thank you for your feedback. I will replace the...

Thank you for your feedback. I will replace the posts with 6x6 an follow code.

To attach the new ledger board (2"x8"x12") to a concrete foundation, could I use Red Head 5-1/2-in x 1/2-in...
Replies: 15
Views: 656
Posted By daguercuzmar

I am replacing the ledger board. Also, noticed...

I am replacing the ledger board. Also, noticed that two beams (2x8) are attached to the side of the post (4x4) with diagonal bracing. Both beams and posts are in excellent condition. The deck is only...
Replies: 15
Views: 656
Posted By daguercuzmar

Sagging ledger board deck

I was replacing the decking of my 10’x12’ deck and noticed that some of the joists were rotten, and the left side of the ledger board , which is anchored to a concrete footing, is moving and cracked...
07-18-14, 03:53 AM
Replies: 1
Views: 2,771
Posted By daguercuzmar

Cat6 blue cable connection to garage door opener

I am trying to install a garage door opener (Craftsman 1/2hp, model 139.53970SRT) using the existing pre-wired blue cable (with four twisted colored wires inside) from the ceiling and garage walls....
Replies: 1
Views: 2,528
Posted By daguercuzmar

Frigidaire refrigerator

We have Frigidaire refrigerator model FRS26H5ASB9. This morning, we noticed a rattling noise coming from the back. Four hours later, we lost the cooling system. Could it be the compressor or...
Replies: 2
Views: 763
Posted By daguercuzmar

drivers

I did use the portable system restoration CD. However, reinstalling the operating system requires a manual reinstallation of the drivers. The drives are not automatically installed from the CD,...
Replies: 2
Views: 763
Posted By daguercuzmar

Unhappy installing drivers

I have an old Gateway Solo laptop with Windows NT that crushed. Thus, I had to partition, format the hard disk, and reinstall the Windows NT operating system. Everything seems OK except that,...
04-24-08, 11:24 AM
Replies: 1
Views: 1,118
Posted By daguercuzmar

A/C not working properly

:( Hello everyone,

After letting the A/C rest for the winter, I turned it on this weekend and we noticed that the air is moving through the vents; however, it is not cooling at all. I checked the...
Replies: 23
Views: 1,405
Posted By daguercuzmar

Yes, I have tried loging in as the administrator,...

Yes, I have tried loging in as the administrator, as my wife's and son's log in and does the same thing. If we got a virus, I can not even go any webb site to download an anti-virus software.
Showing results 1 to 25 of 29
 


 
Forum Jump