Search: Posts Made By: RSKadish
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 6
Views: 316
Posted By Zorfdt

That whole black plastic socket can unscrew and...

That whole black plastic socket can unscrew and be replaced. See the U-piece that holds the harp, then there's a nut holding that down. The socket just screws into that same post. Unscrew and...
10-01-20, 04:49 AM
Replies: 8
Views: 948
Posted By johnam

This might apply to your blinds. ...

This might apply to your blinds.
https://cdn2.hunterdouglas.com/static/documents/horizontal-blinds-install-two-inch-plus_3.pdf
09-30-20, 10:30 AM
Replies: 8
Views: 948
Posted By XSleeper

A lot of blinds have a tab in back behind the...

A lot of blinds have a tab in back behind the blind that releases the back edge, which allows you to roll the bottom of the blind toward you. On long blinds you have to release all the clips to get...
09-30-20, 09:36 AM
Replies: 8
Views: 948
Posted By Pilot Dane

In most cases you just look and see how they are...

In most cases you just look and see how they are attached. Some blinds slide onto mounting brackets and you tip the outer edge of the blind up to get the tab of the bracket out of a slot on the...
09-30-20, 09:35 AM
Replies: 8
Views: 948
Posted By Shadeladie

The end of the bracket should flip up or out. ...

The end of the bracket should flip up or out. Can be difficult. Are they faux blinds? Faux tends to be heavy but real wood is very light.
Replies: 2
Views: 141
Posted By PJmax

The receiver has the fan speed components in it...

The receiver has the fan speed components in it so that it needs to be used to get the fan to operate correctly. It is part # 87075-02. You can search using that part number.

New receiver...
02-08-20, 03:32 PM
Replies: 13
Views: 1,483
Posted By Norm201

I'm just throwing this out for a possible...

I'm just throwing this out for a possible consideration. Using a low or no expanding fill foam (something like Great Stuff), but using caution to not let it blow out the thin metal left. It might...
02-08-20, 08:23 AM
Replies: 13
Views: 1,483
Posted By joecaption

Sanding not going to do a thing on this one. ...

Sanding not going to do a thing on this one.
Going to need a wire cup wheel, one that fits in a drill will work.
Then I'd hit it with a rust converter, let dry, gray rusty metal primer then the...
Showing results 1 to 8 of 8


 
Forum Jump