Search: Posts Made By: JFCarbonneau
Showing results 1 to 11 of 11
Search took 0.01 seconds.
01-25-13, 01:35 PM
Replies: 7
Views: 16,161
Posted By JFCarbonneau

Thanks a lot for the good advices, highly...

Thanks a lot for the good advices, highly appreciated.

JF
01-23-13, 04:28 PM
Replies: 7
Views: 16,161
Posted By JFCarbonneau

Thank you BridgeMan45, this is very helpful. I...

Thank you BridgeMan45, this is very helpful. I tried unsuccessfully to find your previous post about surface preparation, can you help?

One more question also; In most area, the concrete floor...
01-21-13, 08:11 AM
Replies: 7
Views: 16,161
Posted By JFCarbonneau

New slab over old one?

I want to finish the basement in my house built in 1950. The basement is 9 foot high and there is an old concrete floor that shows bumps and dips (and cracks) here and there. In addition, there is...
Replies: 1
Views: 2,949
Posted By JFCarbonneau

Water infiltration behind brick wall?

I own a two story building with brick exterior. The building is approximately 50 years old but the brick’s joints have been repaired approximately 15 years ago.

For some reasons, I am getting...
Replies: 7
Views: 6,272
Posted By JFCarbonneau

1/2" or 3/4" PEX in slab?

Hi,

I am planning the radiant slab installation in our new house in NH. Slab is approximately 1,500 sf.

I have to decide between 1/2" PEX spaced at 12" (5 rolls of 300ft) or 3/4" PEX spaced...
Replies: 3
Views: 947
Posted By JFCarbonneau

Help!!! Pouring foundation and need to prep vent

We are pouring our foundation walls on this Friday, May 28th and I need to know how to prep the pass-through in the concrete wall for a propane direct-vent Triangle Tube Prestige Excellence PE110...
Replies: 2
Views: 1,035
Posted By JFCarbonneau

Submersible pump in surface well?

Hi,

I need to replace my jet pump and I am thinking about replacing it by a submersible pump. My surface well always shows seven to eight feet of water and I would suspend the submersible pump...
Replies: 1
Views: 1,177
Posted By JFCarbonneau

Oil burner shut down problem Help!

Hi there,

I have a 3 years old Carlin oil burner installed on a OWB & OWT boiler. When the thermostat reach its set temperature and shut down the furnace, the oil burner will cycle on and off...
Replies: 8
Views: 1,296
Posted By JFCarbonneau

Thank you Trooper and Dave, This is all very...

Thank you Trooper and Dave, This is all very helpful discussion.

Best,

JF
Replies: 8
Views: 1,296
Posted By JFCarbonneau

Thank you Bud, Do you think possible that...

Thank you Bud,

Do you think possible that the excessive oil used is caused by the fact that the tubing is under floor?

Thanks again,

JF
Replies: 8
Views: 1,296
Posted By JFCarbonneau

Underfloor hydronic in the Northeast?

Hi,

My wife and I are in the process of buying a modular home in New Hampshire and we would like to use radiant floor as our main source of heating. We have heard however that underfloor radiant...
Showing results 1 to 11 of 11


 
Forum Jump