Search: Posts Made By: Lar57
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Replies: 9
Views: 2,482
Posted By Lar57

One thing I forgot to mention when adjusting the...

One thing I forgot to mention when adjusting the governor shaft, I noticed there seemed to be a detent or obstruction when rotating the shaft. If slightly torqued higher, then you could obtain about...
Replies: 9
Views: 2,482
Posted By Lar57

Thanks for all the comments. I'll retry adjusting...

Thanks for all the comments. I'll retry adjusting the governor, but I'm pretty certain I tried this already. Based on the comments, I'm becoming more concerned the governor is not working properly. I...
Replies: 9
Views: 2,482
Posted By Lar57

yea, in the process of removing the gas tank I...

yea, in the process of removing the gas tank I disconnected the governor from the linkage. During re-assembly, I have tried rotating the gov shaft in both extremes, and tightening the tension bolt....
Replies: 9
Views: 2,482
Posted By Lar57

Yes, manual movement of the governor arm, or...

Yes, manual movement of the governor arm, or rotating the governor pin the arm is attached to, will control the throttle position. The problem seems to be there is no "springback", or motion to close...
Replies: 9
Views: 2,482
Posted By Lar57

Question on throttle adjustment for 5 hp B&S carb

Iím stumped. Been working on a B&S 5 hp (model 132212) carburetor that is on a 20 year old log splitter. I disassembled the carb, cleaned it, and put in a new kit. Runs great, the only problem is the...
Showing results 1 to 5 of 5


 
Forum Jump