Search: Posts Made By: ktkodama
Showing results 1 to 14 of 14
Search took 0.01 seconds.
Replies: 6
Views: 15,173
Posted By ktkodama

Shorttimer, Try this, 1. Push the wall...

Shorttimer,

Try this,
1. Push the wall button and hold it down until the door is all the way down, then release the button.
2. Look at the sensor with the red LED while the door is closing,...
11-16-08, 05:05 PM
Replies: 10
Views: 63,854
Posted By ktkodama

peglegpiney, Sounds like you have an 8' to...

peglegpiney,

Sounds like you have an 8' to 10' wide door. Gunguy45 is correct you need a support strut attached to the top of that panel. I am going to assume that the spring or springs have lost...
Replies: 2
Views: 5,804
Posted By ktkodama

creoledude, Do you have a security + garage...

creoledude,

Do you have a security + garage door opener and a multi function door control?
Replies: 3
Views: 3,528
Posted By ktkodama

It sounds like you need a new bottom seal for...

It sounds like you need a new bottom seal for your garage door. I am going to assume that you have steel doors. There are a few different types of bottom seal for steel garage doors, so it depends on...
Replies: 7
Views: 5,616
Posted By ktkodama

Sharif, Sounds like you have an old brown...

Sharif,

Sounds like you have an old brown case sears chain drive opener. Unfortunately I don't know of any manufactures that make a 9-dip switch remote that will work for your unit anymore.
...
Replies: 6
Views: 13,423
Posted By ktkodama

Sears Garage Door Opener Won't Open

Rabong,

I am going to assume that you have a chain driven garage door opener model, security plus. I am also going to assume that you live on the east coast.

There are a few things that I need...
Replies: 3
Views: 906
Posted By ktkodama

Do you have a push button or a wall console? Is...

Do you have a push button or a wall console? Is the garage door opener lock feature engauged?
Replies: 3
Views: 906
Posted By ktkodama

If the light on the garage door opener blinks ten...

If the light on the garage door opener blinks ten times and you hear a clicking sound ten times then that means that the safety sensors are misaligned.
10-06-08, 05:51 AM
Replies: 1
Views: 2,584
Posted By ktkodama

Yes, your garage door opener can be fixed. You...

Yes, your garage door opener can be fixed. You will need to replace the gear and sprocket shaft. If you are pretty handy it takes about 15-20 minutes, you will also want to make sure that your garage...
09-26-08, 05:32 AM
Replies: 1
Views: 1,446
Posted By ktkodama

Yes, it sounds like a the internal gear needs to...

Yes, it sounds like a the internal gear needs to be replaced. There should also be a manufacture date on the back of the garage door opener, if you are interested.

Check your garage door to make...
Replies: 3
Views: 6,147
Posted By ktkodama

I would just call someone. The more you mess with...

I would just call someone. The more you mess with it the more it will cost in the long run. There is quite a bit of tension behind those springs and nobody wants to get hurt. Gunguy45 is correct it...
Replies: 1
Views: 1,324
Posted By ktkodama

CJRBK14 Try/Look at these. 1. Is your...

CJRBK14

Try/Look at these.
1. Is your garage door rubbing against the door jambs?
1a. Try rubbing some candle wax on the jambs to get the door to run a little smoother.
1b. Loosen the jamb...
Replies: 5
Views: 2,033
Posted By ktkodama

Rodman If you contact Chamberlain (LiftMaster)...

Rodman
If you contact Chamberlain (LiftMaster) you can order a 915LM wireless garage door monitor. They are very easy to install and you can place the monitor anywhere in your home close to an...
Replies: 7
Views: 17,390
Posted By ktkodama

Have you already removed the motor?

Have you already removed the motor?
1. If you have you need to put it back in before you remove the roll pins.
2. You can use a punch that is the same size as the roll pin and knock it out.
3. If...
Showing results 1 to 14 of 14


 
Forum Jump