Search: Posts Made By: ron2368
Showing results 1 to 12 of 12
Search took 0.01 seconds.
04-21-20, 02:36 PM
Replies: 1
Views: 240
Posted By ron2368

Holly type plant problem

I can't remember the name, its about 18 feet tall and has holly leaves so I will call it Holly. The bark has dimples everywhere, almost like tiny raised eruptions. The bark in these areas is soft and...
01-04-15, 11:38 AM
Replies: 1
Views: 634
Posted By ron2368

Maytag Gas Range CRG9700

This range was purchased in 1996. After using it for baking yesterday, the oven will not work. The broiler works and the oven temps display on the range. I took out the oven base and the iginitor is...
Replies: 1
Views: 1,041
Posted By ron2368

Maytag rtd2300 has lots of moisture

Its about 18 yr old top freezer model. The freezer and refrigerator both maintain good temps. I checked the defrost pan and it had about 10 oz of water in it. The top of the refrigerator area has...
01-05-14, 10:47 AM
Replies: 1
Views: 2,516
Posted By ron2368

Can I replace cantilever with a v brake

I have an old trek 820 that has shimano mountain exage cantilever and they are old, the spacing looks ok for a V brake but will the posts accept a v brake? thanks
12-11-13, 06:05 PM
Replies: 2
Views: 757
Posted By ron2368

How can I find the correct parts for gas furnace.

I have a Payne gas furnace thats about 3 years old and I would like to keep a spare ignitor and flame sensor. Their website has no info about these parts so I dont have any idea where to look except...
Replies: 1
Views: 885
Posted By ron2368

Want to patch hole in bumper

Have an 00 civic that was hit in front bumper. I used epoxy to bond the cracked area but have a hole about 2 by 2 inch. Other than finding a thick piece of plastic and using more epoxy!!!. Its bit...
05-24-13, 07:08 PM
Replies: 11
Views: 8,921
Posted By ron2368

There were 3 different capacitors strapped into...

There were 3 different capacitors strapped into the unit I suppose other repairers did not take them out, they all were 5/370 or 7.5 370 units. I have the wiring diagram but I cant tell much from it....
05-24-13, 03:06 PM
Replies: 11
Views: 8,921
Posted By ron2368

I put in the new motor and capacitor When I...

I put in the new motor and capacitor

When I turn the system I can see a large spark in the motor as it starts, it runs fine for 60 seconds +- then another large spark and it stops. This is with 2...
05-24-13, 10:19 AM
Replies: 11
Views: 8,921
Posted By ron2368

The motor that was in the system working for the...

The motor that was in the system working for the past 5 years is 115v, the pull from another system in the building is 115v, this is a YORK heat pump dated about 1980, I will try to check another...
05-23-13, 07:21 PM
Replies: 11
Views: 8,921
Posted By ron2368

thanks for help

The one I put in was a working unit w cap so I assumed it would work. I am going to buy a new one tomorrow 5mfd 370vac oval run capacitor The fan I purchased is
Fasco D727 5.6-Inch Direct Drive...
05-23-13, 03:19 PM
Replies: 11
Views: 8,921
Posted By ron2368

I have 3 capacitors and have tried each with the...

I have 3 capacitors and have tried each with the same result. When I started the motor with no blade it would run more often than not so I thought the same that the fan was not getting juiced...
05-23-13, 10:02 AM
Replies: 11
Views: 8,921
Posted By ron2368

Lightbulb AC condenser fan shuts off

I had the outside fan shutting off or not starting , when it did run would last couple of minutes, compressor runs fine. If I give the fan blade some momentum it will run for a minute then shut...
Showing results 1 to 12 of 12


 
Forum Jump