Search: Posts Made By: John How
Showing results 1 to 11 of 11
Search took 0.01 seconds.
07-06-19, 04:50 PM
Replies: 1
Views: 1,101
Posted By John How

Interesting. I left it with the 7 red blinks...

Interesting.
I left it with the 7 red blinks blinking and the thermostat left to call for heat. Returned an hour later and the house was hot, and the furnace running properly. Maybe it fixed...
07-06-19, 11:15 AM
Replies: 1
Views: 1,101
Posted By John How

Trane XL 80 no ignition

With encouragement from this forum, I successfully replaced the control board. Of course it is not perfect, since without rewiring the only way it would fit was upside down!
So at first the...
06-08-19, 01:28 PM
Replies: 2
Views: 2,089
Posted By John How

That's my pic, so I'm good to go. Funny that the...

That's my pic, so I'm good to go. Funny that the generic wiring diagram seemed to show
Certain posts for certain destinations, but that's my poor schematic reading, I guess.
Thank you - you helped...
06-08-19, 12:20 PM
Replies: 2
Views: 2,089
Posted By John How

Replacing Contrtol Board on Trane XL80

My ancient furnace was acting up, so the service guy came, and on the second visit, the furnace misbehaved for him too and he determined that I needed a new control board.
I had no reason to...
06-30-18, 04:40 PM
Replies: 10
Views: 621
Posted By John How

That's right, each pendant has its own...

That's right, each pendant has its own transformer in its box, and it is a cable type. And yes indeedy, they are fussy, and pricey.

john
06-30-18, 02:09 PM
Replies: 10
Views: 621
Posted By John How

Whoops - my post disappeared. I'll try again. ...

Whoops - my post disappeared. I'll try again.

All parts of the systme seem compatible. The Leviton Dimmer with Slide Bar DSLO6 says its good for
"Dimmable LED/CFL.." and all others. The VIVID...
06-29-18, 10:55 AM
Replies: 10
Views: 621
Posted By John How

So - I exposed the ceiling box for the dark...

So - I exposed the ceiling box for the dark light. There are 120 volts at the box.

Is there a way to test the transformer? That's the only thing left, I think.


I did change places for the...
06-29-18, 08:57 AM
Replies: 10
Views: 621
Posted By John How

Thanks Ray and Geo. Subsequent to my post I...

Thanks Ray and Geo.
Subsequent to my post I realized that the fact that there is a transformer between the switch and the light means that when on the switch will read 12 v. In fact there are two...
06-28-18, 05:45 PM
Replies: 10
Views: 621
Posted By John How

Wall switch for LED

Hi all

My first visit.
Trying to wire in two new pendant low voltage LED fixtures. They replace older halogen
12 volt fixtures. Very peculiar results.
First, both LEDs lit, but blinked. I...
12-22-12, 11:51 AM
Replies: 3
Views: 853
Posted By John How

I discover that the unit does light when the one...

I discover that the unit does light when the one to its rear is alight. I guess we can live with that. I've not found the ID plate as yet but will look further so I can finds the part I need.
...
12-21-12, 03:00 PM
Replies: 3
Views: 853
Posted By John How

Range burner doesn't light

I have an old Whirlpool counter top four-burner gas range - with a downdraft fan in the center. Only one of the burners does not ignite. It does not make the sparking noise at the appropriate dial...
Showing results 1 to 11 of 11


 
Forum Jump