Search: Posts Made By: gilmorrie
Showing results 1 to 14 of 14
Search took 0.02 seconds.
Replies: 9
Views: 168
Posted By PJmax

poco = power company. The service coming into...

poco = power company.
The service coming into your house is 120/240v on 3 wires.
There are two hot legs with 240v between them. Between each hot leg and neutral is 120v.

So the 120v loads in...
Replies: 8
Views: 515
Posted By rbeck

The use of two monoflow tees is to overcome the...

The use of two monoflow tees is to overcome the higher resistance to flow in the small kick space heaters. The use of two tees, one installed in the proper direction and one backwards is to achieve...
Replies: 24
Views: 766
Posted By poorplmbr

@spott21, not just your opinion my man. Becomes...

@spott21, not just your opinion my man. Becomes very tiring.
Replies: 24
Views: 766
Posted By spott21

POST #19 Fixing HyVent on air scoopt will...

POST #19

Fixing HyVent on air scoopt will not vent air at high points of zones either during refill or normal operation.

Old style auto vents frequently failed and were capped off, ending...
Replies: 2
Views: 176
Posted By rbeck

Don't forget you will also have to rewire some of...

Don't forget you will also have to rewire some of the boiler depending on what safety's you may have.
If the old pilot is clamped somewhere you may have to find a way of mounting the pilot. Post a...
Replies: 2
Views: 176
Posted By PJmax

Any kit would require a gas valve change. There...

Any kit would require a gas valve change.
There is direct spark ignition and there is a pilot with spark ignition.

I'm not the pro in this area but I do servicing. I've always been afraid of...
Replies: 24
Views: 766
Posted By spott21

A To bleed your system you will isolate each...

A
To bleed your system you will isolate each zone when bleeding. With the lever on the feed valve increase and maintain 25-28 psi which will force the water through the open zone and out of the...
Replies: 19
Views: 521
Posted By spott21

To follow up on Gil's response if you you do have...

To follow up on Gil's response if you you do have the pump with the check valve, then you do not need that defective valve but since you have the room I would replace it with another plain ball valve...
Replies: 7
Views: 306
Posted By spott21

Air does not have to be a continuous problem. A...

Air does not have to be a continuous problem. A hot water system is a closed loop system and if pressurized and bled properly the first time, unless you have a leak or drain the system for repairs or...
Replies: 7
Views: 306
Posted By 2john02458

Radiators only need to be bled if there is air in...

Radiators only need to be bled if there is air in them significantly affecting output. If system pressure is constant (i.e stays at 12# or above when cool--it might go higher when hot) and there are...
Replies: 18
Views: 1,111
Posted By spott

Steamboy is right on point. Have personally had...

Steamboy is right on point. Have personally had monoflo since 85 without incident.
Replies: 18
Views: 1,111
Posted By Steamboy

Combine this information with what you learned on...

Combine this information with what you learned on "heating help" and I think you get your questions answered. That mono-flo system is great and the cost to replace a good working boiler will never be...
Replies: 66
Views: 3,118
Posted By spott

DH, I simply asked what your staement was based...

DH,
I simply asked what your staement was based on. In your first paragragh which was only a description of the operation of an air scoop, which you got elsewhere and was not from your own...
Replies: 26
Views: 1,673
Posted By spott

Rockledge, Merry Christmas. Don't let doughess...

Rockledge,
Merry Christmas. Don't let doughess spoil your Christmas with his usual needless banter. He has a bad habit of either reading half a post or not understanding what he reads. My guess is...
Showing results 1 to 14 of 14


 
Forum Jump